Can you help by answering this question?

Long distance railways use for their electric traction

23 views
in Electric Traction by

Related questions

0 answers 19 views

What is the movement of electrons from atom to atom is called?

asked Mar 14, 2018 in Electrical Engineering by Quiz
1 answer 31 views

Is the speed of alternator is directly proportional to frequency?

asked Mar 18, 2018 in Alternator by Shimroz123
1 answer 18 views

Power in the wind is proportional to

asked May 1, 2018 in Utilization of electrical energy by Shimroz123
1 answer 27 views

Specific energy consumption of an electric train is the ratio between (A) Specific energy output at driving wheels and efficiency of the traction motor (B) Specific energy output at driving wheels and efficiency of the transmission gear (C) Specific energy output of driving motor and efficiency of the driving wheels (D) Specific energy output at driving wheels and efficiency of the (motor + transmission gear)

asked Apr 28, 2018 in Power Electronic Controlled Drives by Shimroz123
1 answer 10 views

What happens to the capacitance if mica is inserted between the plates of an air capacitor? A) The capacitance increases B) The capacitance decreases C) The capacitance remains the same D) The capacitance becomes zero

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
0 answers 13 views

Is a train a locomotive?

asked Mar 11, 2018 in Utilization of electrical energy by Quiz
0 answers 42 views

Why is pulse train gating preferred over pulse gating? Explain with relevant circuit and waveforms, the pulse train gating of SCRs.

asked Mar 11, 2018 in Power Electronics by Quiz
1 answer 25 views

An air gap is usually inserted in magnetic circuits to?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 4 views

State the functions of following elements: i) Diesel engine system ii) Air intake system iii) Engine exhaust system iv) Engine starting system.

asked Sep 7, 2018 by Shimroz123
1 answer 5 views

Explain fuel system and air intake system in diesel electric power plant.

asked Sep 8, 2018 by Shimroz123
1 answer 7 views

Describe with neat diagram air friction damping. 

asked Sep 5, 2018 by Shimroz123
1 answer 18 views

Which of the following is the name given to resistance of thin films that are uniform in thickness? A) Area resistance B) Sheet resistance C) Filmy resistance D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 20 views

How does the resistance of a conductor compare to that of an insulator?

asked Jun 29 by Shimroz123
2 answers 31 views

What happens to the resistance of a wire when its length as well as the cross-sectional area are doubled? A) It doubles B) It becomes 4 times C) It becomes 2π times D) It remains the same

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 17 views

A PMMC instrument has FSD of 100 μA and a coil resistance of 1 kΩ. To convert the instrument into an ammeter with full scale deflection of 100 mA, the required shunt resistance is (A) 1 Ω (B) 1.001 Ω (C) 0.5 Ω (D) 10 Ω

asked Apr 28, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 32 views

Ratio of the rotor reactance X to the rotor resistance R for a two-phase servo motor (A) is equal to that of a normal induction motor (B) is less than that of a normal induction motor (C) is greater than that of a normal induction motor (D) may be less or greater than that of a normal induction motor

asked Apr 28, 2018 in Electronics Engineering by Shimroz123
1 answer 23 views

We connected a 35V dc supply to a resistance of 600 Ohm in series with an unknown resistance R.A. voltmeter having a resistance of 1.2 kOhm is connected across 600 Ohm resistance and read 5v. The value of resistance R will be

asked May 8, 2018 in Electrical Engineering by Shimroz123
1 answer 18 views

A moving coil meter has a resistance of 3 Ω and gives full scale deflection with 30 mA. To measure voltage up to 300 V, the external resistance to be connected in series with the instrument is (A) 9997 Ω (B) 10000 Ω (C) 997 Ω (D) 10003 Ω

asked Apr 28, 2018 in Power Electronic Controlled Drives by Shimroz123
1 answer 17 views

Name the method used to measure following resistances:- (i) Low resistance (ii) Medium resistance (iii) Insulation resistance (iv) Earth resistance.

asked Sep 6, 2018 by Shimroz123
1 answer 6 views

Define the following terms as referred to battery. a) E.M.F b) Internal resistance c) Ah efficiency d) WAh efficiency

asked Sep 4, 2018 by Shimroz123
1 answer 15 views

What happens to the resistance when the current increases?

asked Mar 15, 2018 in Electrical Engineering by Quiz
1 answer 60 views

If the insulation resistance of a cable of length 10 km is 1 mega ohm, its insulation resistance for 50 km length will be

asked May 8, 2018 in Electric Power Transmission by Shimroz123
1 answer 56 views

What is the resistance of a coil which draws 10 A and dissipates 1520 W? A) 152 Ω B) 15.2 Ω C) 1.52 Ω D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 23 views

Consider a cube of material of sides 1 cm with a resistance of 0.003 Ω between its opposite faces. What is the resistance if the same volume of the material is drawn into a length of 50 cm with a uniform cross – section? A) 0.003 Ω B) 0.15 Ω C) 7.5 Ω D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 60 views

What is the resistance of a 160 m wire with a uniform diameter of 0.28 mm, if the specific resistance is 12.32 μΩ-cm? A) 3.2 Ω B) 3.2 μΩ C) 0.8 Ω D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 22 views

What is the total resistance if 5 resistors of 20 Ω each are connected in series? A) 100 Ω B) 4 Ω C) 20 Ω D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 16 views

The transducer with negative temperature co-efficient of resistance is (A) Thermistor (B) Resistance Thermometer (C) Strain Gauge (D) Thermocouple

asked Apr 25, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 39 views

The normal value of the armature resistance of a d.c. motor is?

asked Mar 26, 2018 in DC motor by Shimroz123
1 answer 25 views

International ohm is defined in terms of the resistance of?

asked Mar 25, 2018 in Basic concepts by Shimroz123
2 answers 30 views

The hot resistance of the bulb's filament is higher than its cold resistance because the temperature co-efficient of the filament is?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 27 views

The resistance of a few meters of wire conductor in closed electrical circuit is?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 20 views
1 answer 36 views

A 200 V dc shunt motor is running at 1000 rpm and drawing a current of 10 A. Its armature winding resistance is 2 Ohm. It. is braked by plugging. The resistance to be connected in series with armature to restrict armature current to 10 A, is

asked May 3, 2018 in Electrical Machine by Shimroz123
1 answer 43 views

Temperature co-efficient of resistance is expressed in terms of?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 37 views

If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes?

asked Mar 25, 2018 in Basic concepts by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,450 questions

7,047 answers

132 comments

3,085 users

...