# The resolved part of the resultant of two forces inclined at an angle 9 in a given direction is equal to?

41 views

The resolved part of the resultant of two forces inclined at an angle 9 in a given direction is equal to

The resolved part of the resultant of two forces inclined at an angle 9 in a given direction is equal to the algebraic sum of the resolved parts of the forces in the given direction.

## Related questions

The algebraic sum of the resolved parts of a number of forces in a given direction is equal to the resolved part of their resultant in the same direction. This is as per the principle of

If two equal forces of magnitude P act at an angle 9°, their resultant will be

Two non-collinear parallel equal forces acting in opposite direction?

The forces, which meet at one point, but their lines of action do not lie in a plane, are called?

A number of forces acting at a point will be in equilibrium if?

According to principle of transmissibility of forces, the effect of a force upon a body is?

The algebraic sum of moments of the forces forming couple about any point in their plane is?

If a number of forces act simultaneously on a particle, it is possible?

According to law of triangle of forces?

Forces are called concurrent when their lines of action meet in?

The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of______degrees.

Tangent of angle of friction is equal to?

If a rigid body is in equilibrium under the action of three forces, then?

The Lissajous pattern observed on screen of CRO is a straight line inclined at 45° to x axis. If X–plate input is 2 sin ωt, the Y–plate input is (1) 2 sin ωt (2) 2 sin (ωt + 45°) (3) 2 sin (ωt – 45°) (4) 22 sin ωt + 45°)

Two metallic blocks having masses in the ratio 2:3 are made to slide down a frictionless inclined plane starting from rest position. When the blocks reach the bottom of the inclined plane, they will have their kinetic energies in the ratio : (A) 2:3 (B) 3:5 (C) 3:2 (D) 7:4

Bandwidth of an RC coupled amplifier is 100 kHz. Two such amplifiers are connected in cascade.Resultant bandwidth(in kHz) is around  A) 200 B) 100 C) 60 D) 30

In an AC transmission line difference in phase of voltage at two ends of the line is due to (a) System voltage (b) Insulators (c) Resistance of line (d) Reactance of line

What will be the phase angle between two alternating waves of equal frequency, when one wave attains maximum value the other is at zero value ?

For a transient stability analysis, as long as equal area criterion is satisfied, the maximum angle to which rotor angle can oscillate is:  (A) 0˚ to 20˚ (B) 45˚ to 50˚ (C) Greater than 90˚ (D) 65˚ to 85˚

The maximum power in a synchronous motor (for a given excitation) is produced when the power angle is equal to: (A) 0° (B) 45° (C) 60° (D) 90°

A single-phase fully controlled thyristor bridge ac-dc converter is operating at a firing angle of 25o and an overlap angle of 10o with constant dc output current of 20 A. The fundamental power factor (displacement factor) at input ac mains is  (A) 0.78 (B) 0.827 (C) 0.866 (D) 0.9

At slip equal to infinity, the torque of a three phase induction motor is :-  a) zero b) very small c) high d) very high

Two coplanar couples having equal and opposite moments

A trolley wire weighs 1.2 kg per meter length. The ends of the wire are attached to two poles 20 meters apart. If the horizontal tension is 1500 kg find the dip in the middle of the span?

The gain of a parabolic dish antenna of 1 m diameter -and 80% efficiency at 9.5 GHz is: a. 39 dB b. 78 dB c. 40 dB d. 45 dB

A alternator is delivering power to a balanced load at unit power factor. The phase angle between the line voltage and the line current is? (A) 90° (B) 60° (C) 30° (D) 0°

In which type of the faults given below, all of the three components Ia0, Ia1 and Ia2 are equal?  (A) Single line to ground fault (B) Double line to ground fault (C) Line to line fault (D) 3 phase faults

Angle of friction is the?

Velocity of an electron (in km/S) starting at rest and travelling to a point 100 V above the starting potential is around  A) 3600 B) 4000 C) 5100 D) 6000

A pair of synchronous machines on the same shaft may be used to generate power at 60 Hz from given source of power at 50 Hz. Using minimum number of poles for both the machines, the synchronous speed will be (a) 500 r.p.m. (b) 600 r.p.m. (c) 1000 r.p.m. (d) 1200 r.p.m.

An electron having an energy of 20 eV enters a magnetic field of 0.02 webers/sqm at an angle of 30degrees to the field. The time of travel (in nS)of the electron for one revolution is about  A) 1.78 B) 4.21 C) 7.82 D) 10.24

In wound rotor alternator, reactive power is maximum at a load angle of

Two transformers are connected in parallel. These transformers do not have equal percentage impedance. This is likely to result in?

In an ac series RLC circuit, the voltage across R and L is 20 V; voltage across L and C is 9 V and voltage across RLC is 15 V. What is the voltage across C?

If a suspended body is struck at the center of percussion, then the pressure on die axis passing through the point of suspension will be?

In a control system the output of the controller is given to?

In a three-phase system, when the loads are perfectly balanced, the value of neutral current is equal to: A. Zero B. One-third of the maximum value C. Two -third of the maximum value D. The maximum value

If eight -tenths coulomb passes a point in 4 s, the value of current is equal to: A. 1.6 A B. 16 A C. 2 A D. 0.2 A