# The power consumed in a circuit element will be least when the phase difference between the current and voltage is?

76 views
The power consumed in a circuit element will be least when the phase difference between the current and voltage is?

The power consumed in a circuit element will be least when the phase difference between the current and voltage is 90°.

## Related questions

The phase difference between voltage and current wave through a circuit element is given as 30°. The essential condition is that?

When the phase difference between two sinusoidal quantities is 90° they are said to be ______ A) Phase right angle B) Phase quadrature C) Phase sinuright D) None of these

The product of apparent power and cosine of the phase angle between circuit voltage and current is?

What is the difference between line and phase current?

What is the difference between line and phase voltage?

What is the power factor when a single phase watt meter operating on 200 V and 5 A for 5 hours makes 2016 revolutions and the meter constant in revolution is 420? A) 0.04 B) 1.04 C) 0.96 D) None of these

What is the difference between eddy current and hysteresis loss?

If resistance is 8 Ohm and current is 16 ampere then what will be the voltage and power?

In an alternator at lagging power factor the generated voltage per phase as compared to that at unity power factor?

What is the difference between a line voltage and low voltage control system?

List any two methods of reactive power measurement in 3 phase circuit.

Explain power relations in three phase circuit.

Explain power in single phase AC circuit.

Describe the difference between an open circuit and a short circuit.

What is the difference between an anode and a cathode?

What is the difference between a coil and an inductor?

Describe the difference between direct and alternating current.

For a balanced three phase star connected load for which line voltage is 230V and per phase resistance and reactance is 6 Ohm and 8 Ohm respectively. Calculate: 1) phase voltage 2) line current 3) power factor 4) total power absorbed

Write the relation between phase and line current, phase and line voltage for Star connection.

What will be the phase angle between two alternating waves of equal frequency, when one wave attains maximum value the other is at zero value ?

Explain why potential difference is necessary to produce current in a circuit.

what is the difference between capacitor and battery ?

What is the difference between a soft start and a VFD?

What is the difference between an insulator and a dielectric?

What is the difference between a sensor and a transducer?

What is the difference between a microcontroller and a microprocessor?

What is the difference between a mesh and a loop?

What is the difference between a blackout and brownout?

What is the difference between a counter and a timer?

What is the difference between a switch and a relay?

What is the difference between relay and contactor?

What is the difference between BJT and FET?

What is the difference between an AC and DC generator?

What is the difference between synchronous and asynchronous generator?

What is the difference between synchronous and asynchronous motors?

What is the difference between microcontroller and ARM processor?

What is the difference between an ECU and an ECM?

What is the difference between DFT and FFT?

What is the difference between AC and DC drive?

What is the difference between analog and digital electronics?

What is the difference between linear and nonlinear electrical loads?