# In series resonant circuit, increasing inductance to its twice value and reducing capacitance to its half value?

21 views

In series resonant circuit, increasing inductance to its twice value and reducing capacitance to its half value?

In series resonant circuit, increasing inductance to its twice value and reducing capacitance to its half value will increase the selectivity of the circuit.

## Related questions

In R-L-C series resonant circuit magnitude of resonance frequency can be changed by changing the value of?

A series R-L-C Circuit has a resonant frequency of 1000 Hz. If the values of R, L and C are doubled, the new resonant frequency is

In a series L-C circuit at the resonant frequency the?

In a series resonant circuit, the impedance of the circuit is?

If resistance is 20 Q. and inductance is 27 in a R-L series circuit, then time constant of this circuit will be?

What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

The series and parallel resonance on L-C circuit differs in that?

In an ac series RLC circuit, the voltage across R and L is 20 V; voltage across L and C is 9 V and voltage across RLC is 15 V. What is the voltage across C?

In a series R-C circuit, with the increase in frequency, current (A) Reduces (B) Increases (C) Does not change (D) Becomes zero

Which of the following is true with a series circuit having resistors of different values? A) The total resistance of the circuit is the sum of the individual resistances B) The current across each resistor is the same C) The voltage drop across each resistor depends on the value of the resistor D) All the above

At very low frequencies a series R-C circuit behaves as almost purely?

The time constant of a series R-C circuit is given by?

In a series RLC high Q circuit, the current peaks at a frequency  (1) equal to the resonant frequency (2) greater than the resonant frequency (3) less than the resonant frequency (4) equal to half the resonant frequency

In a series circuit with unequal resistances?

Series circuit rules

A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

A ferro resonant transformer regulation is also known as?

A parallel combination of capacitance C and resistance R is connected in series with inductance L and small resistance r. Under what condition will the circuit be non-reactive?  (A) C=LR (B) C=LR2 (C) C=L/R2 (D) C=L/R

An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS

We connected a 35V dc supply to a resistance of 600 Ohm in series with an unknown resistance R.A. voltmeter having a resistance of 1.2 kOhm is connected across 600 Ohm resistance and read 5v. The value of resistance R will be

Cells are connected in series in order to?

For a series resonant circuit, at the half power points,which of the following is true?  (a) Current is half of the current at resonance. (b) Resistance is equal to the reactance. (c) The impedance is half the impedance at the resonance. (d) None of the above

An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to secondary turn’s ratio 12:1. The peak inverse voltage is A) 8.62 V B) 12 V C) 19.17 V D) 27.11 V

In an AC. circuit, a low value of kVAR compared with kW indicates?

X L and X C in Series

State the use of shunt and series resistance used in extension of meter.

Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across?

To a highly inductive circuit, a small capacitance is added in series. The angle between voltage and current will _____.

An inductor is connected in series with SCR to protect it from A) Excessive high voltage B) Excessive high dv/dt C) Excessive high di/dt D) Excessive large forward current

In a 2 kW, 200 V, 1000 rpm. DC series motor the torque at full load was found to be 0.3 N -m. The torque at half full load in N -m is :

Series capacitive compensation in EHV transmission line is used to

Two resistors are said to be connected in series when?

The time constant of the capacitance circuit is defined as the time during which voltage?

Two 100W, 200V lamps are connected in series across a 200V supply. The total power consumed by each lamp will be in Watts

What is the total resistance if 5 resistors of 20 Ω each are connected in series? A) 100 Ω B) 4 Ω C) 20 Ω D) None of these

A series RLC circuit resonate at 200 Hz. If the capacitance is increased to four times, the circuit will be in resonance at   (a) 100 Hz (b) 200 Hz (c) 400 Hz (d) 800 Hz

In an induction motor if the flux density is reduced to one-half, of its normal value then the torque will  (1) reduce to one-half (2) reduce to one-fourth (3) remain unchanged (4) increase four times

These self inductance of a circuit is defined as twice the work done against the induced e.m.f. on establishing unit current in the coil. If the current to be established in the coil is doubled, the work done against the induced e.m.f. will be  1. Doubled  2. Halved  3. four times  4. Quarter times

For a resonant circuit with resonant frequency of 1 MHz a, 0 = 50 and R = 400, find the value of C (A) 250 pF (B) 1000 pF (C) 1.25 pF (D) 500 pF

If the output filter capacitor in a power supply actually had a value twice its stated value, which of the following symptoms would be found?   a. The output voltage would be doubled and a small improvement in the ripple voltage would be detected.  b. The ripple voltage would be half of what is expected and a ... output voltage would be detected.  c. The output and ripple voltage would be greater than expected.  d. The output and ripple voltage would be less than expected.

Draw the circuit diagram of crystal oscillator and explain its working.

All the rules and laws of D.C. circuit also apply to A.C. circuit containing?