# At very low frequencies a series R-C circuit behaves as almost purely?

48 views
At very low frequencies a series R-C circuit behaves as almost purely?

At very low frequencies a series R-C circuit behaves as almost purely capacitive.

## Related questions

At ______ frequencies the parallel R-L circuit behaves as purely resistive.

The time constant of a series R-C circuit is given by?

In a series R-C circuit, with the increase in frequency, current (A) Reduces (B) Increases (C) Does not change (D) Becomes zero

A series R-L-C Circuit has a resonant frequency of 1000 Hz. If the values of R, L and C are doubled, the new resonant frequency is

In R-L-C series resonant circuit magnitude of resonance frequency can be changed by changing the value of?

In a series L-C circuit at the resonant frequency the?

In an ac series RLC circuit, the voltage across R and L is 20 V; voltage across L and C is 9 V and voltage across RLC is 15 V. What is the voltage across C?

What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

If resistance is 20 Q. and inductance is 27 in a R-L series circuit, then time constant of this circuit will be?

In an AC. circuit, a low value of kVAR compared with kW indicates?

The series and parallel resonance on L-C circuit differs in that?

In a series RLC high Q circuit, the current peaks at a frequency  (1) equal to the resonant frequency (2) greater than the resonant frequency (3) less than the resonant frequency (4) equal to half the resonant frequency

Which of the following is true with a series circuit having resistors of different values? A) The total resistance of the circuit is the sum of the individual resistances B) The current across each resistor is the same C) The voltage drop across each resistor depends on the value of the resistor D) All the above

In a series resonant circuit, the impedance of the circuit is?

Series rc circuits

In series resonant circuit, increasing inductance to its twice value and reducing capacitance to its half value?

Wire-wound resistors are unsuitable for use at high frequencies because they?

A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

In a series circuit with unequal resistances?

Series circuit rules

Magnitude of current at resonance in R-L-C circuit?

The power factor at resonance in R-L- C parallel circuit is?

Time constant for RC circuit formula τ = RC Where, τ = time constant

Parallel rc circuit

Source free RC circuit 2

Source free RC circuit 3

Source free RC circuit 4

Source free RC circuit 5

Source free RC circuit 6

Source free RC circuit 7

Source free RC circuit 8

Draw the single stage RC coupled amplifier circuit and explain its’s operation.

Accurate measurement of very low resistances is possible with (A) Megger (B) Wheatstone Bridge (C) Kelvin’s Double Bridge (D) Wagner’s Earthing Device

The range of frequencies used in induction heating is :  (A) 0-25 Hz  (C) less than 200 Hz  (B) 50 to 100 Hz  (D) more than 1 kHz

The frequencies and voltage used in Dielectric heating are (A) 10 – 30 MHz, upto 25 kV (B) 50 – 60 Hz, upto 25 kV (C) 10 – 30 MHz, upto 100 V (D) 50 – 60 Hz, 110 V – 230 V

In a R-L-C circuit?

In a loss-free R-L-C circuit the transient current is?

An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS

In a 741 Op-Amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to the (A) applied load (B) internal compensation (C) impedance of the source (D) power dissipation in the chip

In a purely inductive circuit?

At which time power factor of the induction motor is low?