The inductance of a coil can be increased by?

23 views
The inductance of a coil can be increased by?

The inductance of a coil can be increased by choosing core material having high relative permeability.

Related questions

The self inductance of a coil can be measured using (A) Wien’s Bridge (B) Schering Bridge (C) Anderson’s Bridge (D) Wheatstone Bridge

lt the length, number of turns and area of a coil are  doubled, the inductance of the coil

The initial rate of rise of current through a coil of inductance 10 H when suddenly connected to a D.C. supply of 200 V is_______Vs.

Inductance of a coil Varies?

Inductance of coil?

When both the inductance and resistance of a coil are doubled the value of?

For 11kV line the inductance per km per phase will be of the order of:  (A) 1 H (B) 0.1 H (C) 1 mH (D) 0.1 mH

What is the reciprocal of inductance?

What is the difference between a coil and an inductor?

The rate of rise of current through an inductive coil is maximum?

The following circuit has following parameters. Ac=Ag=9cm2 g=30cm N=500 Meur=70000 Find the Inductance of the coil

Inductance affects the direct current flow?

An iron cored inductance coil can be modelled, over a normal operating range of networks ,as A) non-Linear bilateral element B) linear bilateral element C) linear time varying element D) non-linear time invariant element

The purpose of the restraining coil in a biased differential relay is  (A) To reduce CT saturation during fault.  (B) To increase the sensitivity of the relay.  (C) To match the transformation ratio.  (D) To limit the spill current through the relay during heavy external fault.

A PMMC instrument has FSD of 100 μA and a coil resistance of 1 kΩ. To convert the instrument into an ammeter with full scale deflection of 100 mA, the required shunt resistance is (A) 1 Ω (B) 1.001 Ω (C) 0.5 Ω (D) 10 Ω

The potential coil of a single phase dynamometer wattmeter has 4840 Ohm resistance. Voltage across the load is 220 V. With the potential coil connected on the load side, the meter indicates 100 W. Approximate percentage error due to wattmeter connection is (A) 11% (B) 9% (C) 1.1% (D) 3%

A Peterson coil is ________ A) An arc generating coil B) An arc suppressing coil C) An arc inducing coil D) None of these

A moving coil of meter has 100 turns, and a length and depth of 10mm and 20mm respectively. It is positioned in a uniform radial flux density of 200 mT. The coil carrier current capacity is 50 mA. The torque on the coil is

A moving coil meter has a resistance of 3 Ω and gives full scale deflection with 30 mA. To measure voltage up to 300 V, the external resistance to be connected in series with the instrument is (A) 9997 Ω (B) 10000 Ω (C) 997 Ω (D) 10003 Ω

Describe with working of LCR meter for measurement of inductance.

A 100 turn coil has an inductance of 6 mH. If the number of turns is increased to 200, all other quantities remaining the same, the inductance will be:

The bridge method commonly used for finding mutual inductance is (A) Heaviside Campbell bridge (B) Schering bridge (C) De Sauty bridge (D) Wien bridge

The measurement range of an ammeter can be increased by using a:

The resolving power of a spectrometer consisting of collimator, a grating and a telescope can be increased by (A) increasing the angular magnification of the telescope (B) increasing the period of the grating (C) decreasing the period of the grating (D) decreasing the slit-width of the collimator

The conductivity of a conductor can be increased by?

Name the material used for :- (i) Moving coil (ii) Permanent magnet in PMMC instrument.

State the material used for moving coil and former for PMMC instruments.

What is inductance?

Self inductance formula

Self induced voltage across an inductance

Stability of a transmission line can be increased by

Permanent magnet moving coil instruments are used for