# The initial rate of rise of current through a coil of inductance 10 H when suddenly...

39 views

The initial rate of rise of current through a coil of inductance 10 H when suddenly connected to a D.C. supply of 200 V is_______Vs.

The initial rate of rise of current through a coil of inductance 10 H when suddenly connected to a D.C. supply of 200 V is 20 Vs

## Related questions

The rate of rise of current through an inductive coil is maximum?

lt the length, number of turns and area of a coil are  doubled, the inductance of the coil

The inductance of a coil can be increased by?

Inductance of a coil Varies?

The self inductance of a coil can be measured using (A) Wien’s Bridge (B) Schering Bridge (C) Anderson’s Bridge (D) Wheatstone Bridge

Inductance of coil?

Inductance affects the direct current flow?

When both the inductance and resistance of a coil are doubled the value of?

Explain the concept of initial and final conditions in switching for L and C.

What is the value of Inductance of a coil that induces 20 V when the current through the coil changes from 12 to 20 A in 2 seconds? A. 2 H B. 3 H C. 4 H D. 5 H

With rise in temperature the resistance of semi-conductors?

When current flows through heater coil it glows but supply wiring does not glow because?

The unit heat rate characteristic of a thermal power unit shows :  (A) Heat input per kWh of output versus the megawatt output of unit  (B) Heat input per kW of output versus the megawatt output of unit  (C) Heat input per kWh of output versus the megawatt hour output of unit  (D) Heat input per kW of output versus the megawatt hour output of unit

What happens when a current flows through a wire?

When an alternating current passes through an ohmic resistance the electrical power converted into heat is?

When electric current passes through a bucket full of water, lot of bubbling is observed. This suggests that the type of supply is?

If a signal band limited to fm is sampled at a rate less than 2fm, then the constructed signal will be A) Large in amplitude B) Small in amplitude C) Distorted D) Distortion less

The current i(t), through a 10 Ω resistor in series with an inductance, is given by I(t) = 3 + 4sin (100t + 450 ) + 4 sin(300t +600) amperes. The RMS values of the current and power dissipation in the circuit are:  (A) √41 A, 410 W respectively (B) √35 A, 350 W respectively (C) 5 A, 250 W respectively (D) 11 A, 1210 W respectively

When electric current passes through a metallic conductor, its temperature rises. This is due to?

What is the reciprocal of inductance?

The sampling rate to avoid aliasing for the signal m(t) = 100 cos 200ωt will be A) ≥1/25 sec B) ≥1/50 sec C) ≤1/25 sec D) ≤ 1/50 sec

What is the difference between a coil and an inductor?

The following circuit has following parameters. Ac=Ag=9cm2 g=30cm N=500 Meur=70000 Find the Inductance of the coil

Liquid flow rate is measured using (A) a pirani gauge (B) a pyrometer (C) an orifice plate (D) a bourdon tube

The purpose of the restraining coil in a biased differential relay is  (A) To reduce CT saturation during fault.  (B) To increase the sensitivity of the relay.  (C) To match the transformation ratio.  (D) To limit the spill current through the relay during heavy external fault.

A PMMC instrument has FSD of 100 μA and a coil resistance of 1 kΩ. To convert the instrument into an ammeter with full scale deflection of 100 mA, the required shunt resistance is (A) 1 Ω (B) 1.001 Ω (C) 0.5 Ω (D) 10 Ω

The potential coil of a single phase dynamometer wattmeter has 4840 Ohm resistance. Voltage across the load is 220 V. With the potential coil connected on the load side, the meter indicates 100 W. Approximate percentage error due to wattmeter connection is (A) 11% (B) 9% (C) 1.1% (D) 3%

A sine wave voltage is applied across an inductor. When the frequency of the voltage is decreased, the current decreases.

A Peterson coil is ________ A) An arc generating coil B) An arc suppressing coil C) An arc inducing coil D) None of these

The transit time of the current carriers through the channel of a JFET decides it's?

Can you make alternating current through a battery?

For 11kV line the inductance per km per phase will be of the order of:  (A) 1 H (B) 0.1 H (C) 1 mH (D) 0.1 mH

A coil of 500 turns is linked with a flux of 25 mwb, when carries a current of 12.5A. Calculate the value of self-inductance.

A moving coil of meter has 100 turns, and a length and depth of 10mm and 20mm respectively. It is positioned in a uniform radial flux density of 200 mT. The coil carrier current capacity is 50 mA. The torque on the coil is

A moving coil meter has a resistance of 3 Ω and gives full scale deflection with 30 mA. To measure voltage up to 300 V, the external resistance to be connected in series with the instrument is (A) 9997 Ω (B) 10000 Ω (C) 997 Ω (D) 10003 Ω