# Three 60 W bulbs are in parallel across the 60 V power line. If one bulb burns open?

21 views
Three 60 W bulbs are in parallel across the 60 V power line. If one bulb burns open?

Three 60 W bulbs are in parallel across the 60 V power line. If one bulb burns open the other two bulbs will light.

## Related questions

Three 60 W bulbs are in parallel across the 230 V power line. If one bulb burns out

Two light bulbs are connected in series across a 120 V battery. Bulb 1 uses 40 W of power and Bulb 2 uses 20 W of power. If bulb 1 alone is connected to the 120 V source, then it will consume (A) 90 W (B) 80 W (C) 60 W (D) 180 W

Two bulbs of 500 W and 200 W rated at 250 V will have resistance ratio as?

With three resistances connected in parallel, if each dissipates 20 W the total power supplied by the voltage source equals?

Three lamps are connected in parallel across a 120 Volt source. If one lamp burns out, the remaining two will be: A. Glow dimmer B. Glow brighter C. Not light D. Glow with the same brightness as before

Bulbs in street lighting are all connected in?

If a parallel circuit is opened in the main line, the current?

A 220 V, 200 W bulb and a 220 V, 100 W bulb are connected in series across a 220 V supply, the power consumed by them will be (a) 33.3 W (b) 66.6 W (c) 100 W (d) 300 W

Two incandescent light bulbs of 40 Wand 60 W rating are connected in series across the mains, then .  A) The bulbs together consume 100 W B) The bulbs together consume 50 W C) The 60 W bulb glows brighter D) The 40 W bulb glows brighter

Consider a circuit with three parallel branches connected across a DC supply. What is the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio of 2 : 3 : 4 respectively? A) 2 : 3 : 4 B) 6 : 4 : 3 C) 4 : 3 : 2 D) None of these

When one leg of parallel circuit is opened out the total current will?

One 200 V, 100 W bulb is connected in series with primary of a 200 V, 10 kVA transformer. If its secondary is kept open circuited, then the bulb would have (1) Full brightness (2) Poor brightness (3) A little less than full brightness (4) More than full brightness

When three resistors with unequal values are connected in parallel, _______ A) The current across the resistors is the same  B) The voltage drop across the resistors is the same C) The voltage drops across the resistors is proportional to the resistance of each resistor D) None of these

Two series resistors are connected to an ac source. If there are 7.5 V rms across one resistor and 4.2 V rms across the other, the peak source voltage is? A.16.54 V B.1.65 V C.10.60 V D.5.93 V

An A.C. voltage is impressed across a pure resistance of 3.5 ohms in parallel with a pure inductance of impedance of 3.5 ohms?

While keeping the excitation constant, if the steam supply of an alternator running in parallel with another identical alternator is increased, then (A) It would over-run the other alternator (B) Its rotor will fall back in phase with respect to the other machine (C) Its portion of share in load will increase (D) Its power factor would be decreased.

If you used 600 W of power for 60 h, you have used? A.36 kWh B.3.6 kWh C.10 kWh D.1 kWh

The power factor at resonance in R-L- C parallel circuit is?

A 40 W bulb is connected in series with a room heater. If now 40 W bulb is replaced by 100 W bulb, the heater output will?

Is more power dissipated in series or parallel?

An additional condition for parallel operation of three-phase transformers over single-phase transformers is that

Two 220 volt lamps, one of 60 watt and the other of 75 watt are connected in series across a 440 volt supply. The potential difference across 60 watt lamp will be: A) 195 volt B) 220 volt C) 245 volt D) 440 volt

In an AC circuit, the voltage across R, L and C are 30 V, 60 V and 20 V respectively. The applied voltage is (A) 70 V (B) 50 V (C) 60 V (D) 100 V

In parallel RLC resonance circuit at resonance the current will be  (1) Minimum (2) Maximum (3) Zero (4) Infinite

The series and parallel resonance on L-C circuit differs in that?

Two heaters, rated at 1000 W, 250 V each are connected in series across a 250 V, 50 Hz ac mains. The total power drawn from the supply would be __________ watt.

Three identical resistors connected in star consume 5000 W. If the resistors are connected in delta across the same supply, the power consumed will be

XL and XC in parallel

A parallel AC. circuit in resonance will?

Two non-collinear parallel equal forces acting in opposite direction?

Three equal impedances are first connected in delta across a 3 -phase balanced supply. If the same impedances are connected in star across the same supply then,

Three identical resistors are first connected in parallel and then in series. The resultant resistance of the first combination to the second will be?

A single phase motor draws a current of 5 A from a 120 V, 60 Hz line. The power factor of the motor is 65%. Calculate the active power absorbed by the motor.  (A) 600 W (B) 390 W (C) 456 W (D) 650 W

State the principle of solar cell. What is necessity of series and parallel connection of solar cells.

At ______ frequencies the parallel R-L circuit behaves as purely resistive.

The purpose of a parallel circuit resonance is to magnify?

Explain the series and parallel operation of MOSFET. Which is suitable and why?

Also, highlight the problem faced during parallel operation.

In a series RLC circuit, the rms value of voltage across the resistor is 30 V, across the inductor is 60 V and across the capacitor is 20 V. The rms supply voltage would be (A) 110 V (B) 10 V (C) 220 V (D) 50 V

Three resistors of 4 Ω, 6 Ω and 9 Ω are connected in parallel. Which resistor consumes the maximum power?  (A) 4 Ω (B) 6 Ω (C) 9 Ω (D) 17 Ω