13 views
in Network Analysis by
Kirchhoff's voltage law applies to circuits with?

1 Answer

0 votes
by

Kirchhoff's voltage law applies to circuits with linear, non-linear, active, passive, time varying as wells as time-in-variant elements.

Related questions

1 answer 10 views

Kirchhoff s law is not applicable to circuits with?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 22 views

Kirchhoffs current law is applicable to only?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 24 views

Kirchhoff's current law states that?

asked Mar 25, 2018 in Network Analysis by Shimroz123
0 answers 10 views

Kirchhoffs voltage law is related to?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 22 views

According to Kirchhoffs voltage law, the algebraic sum of all IR drops and e.m.f. in any closed loop of a network is always?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 18 views

Kirchhoff s law is applicable to?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 15 views

Kirchhoff's voltage law

asked Jun 11 by Shimroz123
1 answer 12 views

Faraday's law of induced voltage

asked Jun 11 by Shimroz123
1 answer 19 views

Between the branch voltages of a loop the Kirchhoff s voltage law imposes?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 15 views

Kirchhoff's current law

asked Jun 11 by Shimroz123
1 answer 28 views
1 answer 19 views

According to law of triangle of forces?

asked Mar 22, 2018 in Engineering Mechanics by Shimroz123
1 answer 17 views

Kirchhoff's current law is applicable to 1. Closed loops in a circuit 2. Junction in a circuit 3. Magnetic circuits Which of the above is/are correct ?  (a) 1 only (b) 2 only (c) 3 only (d) 1, 2 and 3

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 29 views

Which of the following theorems enables a number of voltage (or current) source to be combined directly into a single voltage (or current) source. (1) compensation theorem (2) reciprocity theorem (3) superposition theorem (4) Millman's theorem

asked Apr 29, 2018 in Network Analysis by Shimroz123
1 answer 24 views

A network is said to be under resonance when the voltage and the current at the network input terminals are (A) in phase (B) out of phase (C) in phase quadrature (D) in phase, and have equal magnitudes

asked Apr 28, 2018 in Network Analysis by Shimroz123
1 answer 24 views

To determine the polarity of the voltage drop across a resistor, it is necessary to know?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 29 views

Ohm's law formula

asked Jun 11 by Shimroz123
2 answers 17 views

State and explain Lenz's law.

asked Sep 4, 2018 by Shimroz123
1 answer 61 views

State and explain Ohm's law for magnetic circuit.

asked Aug 10, 2018 in Basic concepts by Quiz
1 answer 28 views

State Faraday's law of electromagnetic induction.

asked Aug 8, 2018 by Quiz
1 answer 34 views

The condition for the validity under Ohm's law is that?

asked Mar 25, 2018 in Basic concepts by Shimroz123
2 answers 78 views

What is the Lenz's law?

asked Mar 14, 2018 in Electrical Engineering by Quiz
1 answer 29 views

What is KCL and KVL law?

asked Mar 10, 2018 in Electrical Engineering by Quiz
2 answers 44 views

What is Coulomb's law ?

asked Nov 11, 2017 in Power Electronics by Quiz
1 answer 72 views

 An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS 

asked Jun 18, 2018 in Electrical Engineering by Shimroz123
1 answer 32 views

Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 446 views

A single core cable is designed to work for a single phase system with a peak voltage of 220 kV. The maximum permissible stress in the dielectric is not to exceed 20 kV/mm. For economical size, the overall core diameter of the cable is (A) 28.2 mm (B) 26.4 mm (C) 24.4 mm (D) 22.0 mm

asked Apr 28, 2018 in Electrical Engineering by Shimroz123
1 answer 31 views

A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

asked Apr 29, 2018 in Network Analysis by Shimroz123
1 answer 28 views

A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled then the voltage across each resistor will

asked Apr 29, 2018 in Network Analysis by Shimroz123
1 answer 17 views

The internal resistances of an ideal current source, and an ideal voltage source are, respectively, (A) 0, ∞ (B) ∞, ∞ (C) ∞, 0 (D) 0,0

asked Apr 28, 2018 in Network Analysis by Shimroz123
1 answer 15 views

An ideal voltage source has?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 17 views

For a voltage source?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 14 views

An ideal voltage source should have?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 7 views

Explain lagging quantity and leading quantity, explain this concept with voltage and current waveform

asked Sep 7, 2018 by Shimroz123
1 answer 22 views

The kVA rating of Three-phase transformer with Voltage = 200V and Current = 100A will be :  (A) 34.64 kVA (B) 75 kVA (C) 20 kVA (D) None of the above

asked May 8, 2018 in Electrical Engineering by Shimroz123
1 answer 30 views

The voltage gains of the amplifier with and without feedback are 20 and 100 respectively. The percentage of negative feedback would be

asked May 3, 2018 in Power Electronics by Shimroz123
1 answer 79 views

A 3-phase voltage source inverter operates in 180° conduction mode with a star connected resistive load. If input dc voltage is 100 V, then the peak to peak output line voltage is :

asked Apr 30, 2018 in Electrical Engineering by Shimroz123
1 answer 156 views

For a 15-bus power system with 3 voltage controlled buses, the size of Jacobian matrix is

asked Apr 27, 2018 in Switchgear And Protection by Shimroz123
1 answer 26 views

For given applied voltage, with the increase in frequency of the applied voltage?

asked Mar 19, 2018 in Transformer by Shimroz123
1 answer 488 views

Explain the principle of ON-OFF control and phase control of AC voltage controller with suitable circuit and waveforms.

asked Feb 14, 2018 in Unit 6 by Quiz
1 answer 33 views

An SSB transmitter produces a peak-to-peak voltage of 200 V across a 100 Ω antenna load. What is the Peak Envelope Power? A) 49.98 W B) 79.98 W C) 99.96 W D) 199.93 W

asked Jun 18, 2018 in Electronics Engineering by Shimroz123
1 answer 20 views

A change of 4% in the supply voltage to an induction motor will produce a change of approximately

asked May 8, 2018 in Electrical Machine by Shimroz123
1 answer 50 views

If 3000 kW power is to be transmitted over a distance of 30 km, the desirable transmission voltage will be.  (A) 11 kV (B) 33 kV (C) 66 kV (D) 132 kV

asked May 8, 2018 in Electric Power Transmission by Shimroz123
1 answer 34 views

An amplifier has a voltage gain of 120. To reduce distortion, 10% negative feedback is employed. The gain of the amplifier with feedback is  (1) 141 (2) 92.3 (3) 9.23 (4) 1.41

asked May 1, 2018 in Power Electronics by Shimroz123
1 answer 26 views

A current controlled voltage source is equivalent to :  (A) series voltage feed -back amplifier (B) shunt current feed -back amplifier (C) shunt voltage feed -back amplifier (D) series current feed -back amplifier

asked Apr 30, 2018 in Electrical Engineering by Shimroz123
1 answer 58 views

An unshielded moving iron voltmeter is used to measure the voltage in an AC circuit. The stray DC magnetic field having a component along the axis will be  (1) unaffected (2) decreased (3) increased (4) either decreased or increased depending on the direction of the DC field

asked Apr 29, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 18 views

In which of the following waveforms is RMS voltage equal to the average voltage? A) Triangle wave B) Square wave C) Sine wave D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 28 views

What happens to the voltage in the secondary when the frequency of the supply in the primary is decreased? A) It increases B) It decreases C) It remains the same D) Cannot say unless the actual percentage increase in the frequency is known

asked Apr 29, 2018 in Electrical Engineering by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,450 questions

7,047 answers

132 comments

3,085 users

...