Can you help by answering this question?

Inverse definite minimum time lag relay is also called....

15 views
in Network Analysis by
An ideal voltage source has?

Your answer

Thanks for your contribution. Feel free to answer this question. Please avoid short answer. Your answer is most welcome. Be genuine.

Upload image or document:

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
Are you a robot ? (Y = Yes / N = No)
To avoid this verification in future, please log in or register.

1 Answer

0 votes
by

An ideal voltage source has zero internal resistance.

Related questions

1 answer 17 views

The internal resistances of an ideal current source, and an ideal voltage source are, respectively, (A) 0, ∞ (B) ∞, ∞ (C) ∞, 0 (D) 0,0

asked Apr 28, 2018 in Network Analysis by Shimroz123
1 answer 14 views

An ideal voltage source should have?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 27 views

what is ideal voltage source?

asked Aug 14, 2017 in Electrical Engineering by Zeeshan
1 answer 28 views

A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled then the voltage across each resistor will

asked Apr 29, 2018 in Network Analysis by Shimroz123
1 answer 31 views

A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

asked Apr 29, 2018 in Network Analysis by Shimroz123
1 answer 30 views

Which of the following theorems enables a number of voltage (or current) source to be combined directly into a single voltage (or current) source. (1) compensation theorem (2) reciprocity theorem (3) superposition theorem (4) Millman's theorem

asked Apr 29, 2018 in Network Analysis by Shimroz123
1 answer 17 views

For a voltage source?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 73 views

 An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS 

asked Jun 18, 2018 in Electrical Engineering by Shimroz123
1 answer 71 views

A voltage source inverter will have better performance if its  (1) load inductance is small and source inductance is large.  (2) both load and source inductance are small.  (3) both load and source inductances are large.  (4) load inductance is large and source inductance is small. 

asked Apr 30, 2018 in Power Electronics by Shimroz123
1 answer 79 views

A 3-phase voltage source inverter operates in 180° conduction mode with a star connected resistive load. If input dc voltage is 100 V, then the peak to peak output line voltage is :

asked Apr 30, 2018 in Electrical Engineering by Shimroz123
1 answer 26 views

A current controlled voltage source is equivalent to :  (A) series voltage feed -back amplifier (B) shunt current feed -back amplifier (C) shunt voltage feed -back amplifier (D) series current feed -back amplifier

asked Apr 30, 2018 in Electrical Engineering by Shimroz123
1 answer 94 views

A voltage source inverter is normally employed when  (1) source inductance is large and load inductance is small (2) source inductance is small and load inductance is large (3) both source and load inductance are small (4) both source and load inductance are large

asked Apr 29, 2018 in Power Electronics by Shimroz123
1 answer 69 views

A single-phase voltage source square -wave inverter feeds pure inductive load. The waveform of the load current will be

asked Apr 29, 2018 in Power Electronics by Shimroz123
1 answer 21 views

A network that consists of at least a voltage source or current source is called A) Active network B) Ideal network C) Sourced network D) Outsourced network

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 32 views

Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 36 views

In voltage source converter based HVDC transmission system the active power is controlled by changing (A) phase angle of the converter ac input voltage (B) supply frequency of the converter ac input voltage (C) magnitude of the converter ac input voltage (D) DC voltage at the inverter terminals

asked Apr 28, 2018 in High voltage engineering by Shimroz123
1 answer 271 views

Justify. Power MOSFET is operated at high enough gate source voltage to minimize the conduction losses. 

asked Dec 7, 2017 in Unit 1 by Quiz
1 answer 68 views

What is Voltage Source Inverter (VSI) ?

asked Aug 9, 2017 in Unit 2 by Zeeshan
1 answer 16 views

Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 24 views

The gain of an ideal amplifier must be

asked Apr 26, 2018 in Control System by Shimroz123
1 answer 14 views

A d.c. source has an open circuit voltage of 30 V and an internal resistance of 1.5 Ohm. A resistive load is connected to the source. Maximum power dissipated in the load is (A) 300 W (B) 150 W (C) 45 W (D) 20 W

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 27 views

What should be the ideal resistance of ammeter ?

asked Mar 8, 2018 in Electronics Engineering by Quiz
1 answer 202 views

What are the desirable characteristics of ideal switch?

asked Feb 5, 2018 in Unit 1 by Quiz
0 answers 13 views

An R-L series AC circuit has R = 10 ohm and XL = 10 ohm. It is connected to an AC voltage source, the phase angle between voltage and current is (a) 30° (b) 45° (c) 60° (d) 36.8°

asked May 25, 2018 in Network Analysis by Shimroz123
1 answer 34 views

An amplifier has a voltage gain of 120. To reduce distortion, 10% negative feedback is employed. The gain of the amplifier with feedback is  (1) 141 (2) 92.3 (3) 9.23 (4) 1.41

asked May 1, 2018 in Power Electronics by Shimroz123
1 answer 24 views

A network is said to be under resonance when the voltage and the current at the network input terminals are (A) in phase (B) out of phase (C) in phase quadrature (D) in phase, and have equal magnitudes

asked Apr 28, 2018 in Network Analysis by Shimroz123
1 answer 13 views

Kirchhoff's voltage law applies to circuits with?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 24 views

To determine the polarity of the voltage drop across a resistor, it is necessary to know?

asked Mar 25, 2018 in Network Analysis by Shimroz123
0 answers 10 views

Kirchhoffs voltage law is related to?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 22 views

According to Kirchhoffs voltage law, the algebraic sum of all IR drops and e.m.f. in any closed loop of a network is always?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 72 views

The voltage gain of a common -source JFET amplifier depends up on its  (1) Input impedance (2) Amplification factor (3) Dynamic drain resistance (4) Drain load resistance

asked Apr 30, 2018 in Power Electronics by Shimroz123
1 answer 16 views

Source free RL circuit 8

asked May 10 by Shimroz123
1 answer 11 views

Source free RL circuit 7

asked May 10 by Shimroz123
1 answer 13 views

Source free RL circuit 6

asked May 10 by Shimroz123
1 answer 9 views

Source free RC circuit 2

asked May 10 by Shimroz123
1 answer 11 views

Source free RC circuit 3

asked May 10 by Shimroz123
1 answer 11 views

Source free RC circuit 4

asked May 10 by Shimroz123
1 answer 9 views

Source free RC circuit 5

asked May 10 by Shimroz123
1 answer 13 views

Source free RC circuit 6

asked May 10 by Shimroz123
1 answer 12 views

Source free RC circuit 7

asked May 10 by Shimroz123
1 answer 18 views

Source free RC circuit 8

asked May 10 by Shimroz123
1 answer 9 views

Source free RL circuit 1

asked May 10 by Shimroz123
1 answer 18 views

Source free RL circuit 2

asked May 10 by Shimroz123
1 answer 12 views

Source free RL circuit 3

asked May 10 by Shimroz123
1 answer 13 views
1 answer 8 views

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,450 questions

7,047 answers

133 comments

3,086 users

...