# A terminal where three on more branches meet is known as?

25 views
A terminal where three on more branches meet is known as?

A terminal where three on more branches meet is known as node.

## Related questions

The number of independent loops for a network with n nodes and b branches is

Consider a circuit with three parallel branches connected across a DC supply. What is the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio of 2 : 3 : 4 respectively? A) 2 : 3 : 4 B) 6 : 4 : 3 C) 4 : 3 : 2 D) None of these

An electrical circuit with 10 branches and 7 junctions will have

A connected graph has ‘5’ number of branches and ‘4’ number of nodes. It's rank is A) 1 B) 2 C) 3 D) 4

In 8085, whenever a signal is received at TRAP terminal, its program execution is transferred to a subroutine on address A) 0000 H B) 002C H C) 0024 H D) 0004 H

The terminal characteristics of a dc generator suitable for electric welders is (A) separately excited generator (B) shunt generator (C) series generator (D) differentially compounded generator

When a capacitor was connected to the terminal of ohmmeter, the pointer indicated a low resistance initially and then slowly came to infinity position. This shows that capacitor is ?

A closed path made by several branches of the network is known as?

What is internal voltage drop and terminal voltage?

What are the different branches of electronics?

A network which contains one or more than one source of e.m.f. is known as?

When the graph of a network has six branches with three tree branches then the minimum number of equations required for the solution of the network is   (A) 2 (B) 3 (C) 4 (D) 5

A two-terminal variable resistor is known as a? A.potentiometer B.thermistor C.rheostat D.wiper

The number of loop equations required to completely analysing a network comprising of 8 independent branches and 6 nodes including the reference node shall be A) 3 B) 2 C) 4 D) 5

Which of the following are known as the short circuit parameters of a 2- port network? (A) Z- parameters. (B) H- parameters. (C) Y- parameters. (D) A,B,C,D, parameters.

The circuit whose properties are same in either direction is known as?

A casting defect which occurs near the ingates as rough lumps on the surface of a casting is known as 1. Shift 2. Sand wash 3. Swell 4. Scab

When a body reflects all the radiations incident on it, then the body is known as   (a) White body (b) Grey body (c) Black body (d) Transparent body

A control system in which the control action is somehow dependent on the output is known as?

If the number of branches in a network is 'B', the number of nodes is 'N' and the number of dependent loops is 'L', then the number of independent node equations will be  (a) N+L–1 (b) B–1 (c) B–N (d) N–1

The circuit has resistors, capacitors and semi-conductor diodes. The circuit will be known as

With n nodes and b branches a network will have   (A) (b+n) links (B) b - n +1 links (C) b -n-1 links (D) b + n + 1 links

The internet standard that allows you to exchange files with other computers on the Internet is known as  (1) HTTP (2) FTP (3) DNS (4) WWW

The steady-state fault current during a 3 phase terminal fault on a generator is limited by: (1) Transient reactance of the generator (2) Sub-transient reactance of the generator (3) Synchronous reactance of the generator (4) DC off—set during the instant of the fault

"In any network containing more than one sources of e.m.f. the current in any branch is the algebraic sum of a number of individual fictitious currents (the number being equal to the number of sources of e.m.f.), each of which is due to separate action of each source of e.m.f., taken in order ... sources of e.m.f. are replaced by conductors, the resistances of which are equal to the internal resistances of the respective sources". The above statement is associated with?

In a PN-junction with open circuit terminal (equilibrium), with P doping higher as compared to N doping (A) N-side depletion region is small as compared to p-side depletion region (B) N-side depletion region is large as compared to p-side depletion region (C) N-side depletion region is same as p-side depletion region (D) Cannot say

The effective resistance of a coil at high frequency is more than its de resistance on account of : -  a) Skin effect b) Proximity effects c) Eddy current losses d) All the above

If a transformer is switched on to a voltage more than the rated voltage?

The CF is known as ________ A. carry flag B. condition flag C. common flag D. single flag

The reverse breakdown phenomenon in a zener diode is known as

____ is known as a computer network in which one centralized, powerful computer is a hub to which many less powerful personal computers or workstations are connected. The clients run programs and access data that stored on the server.  a) Client-Server network b) Extranet c) Internet d) None of the above.

Information that a computer produces and delivers back to the user is known as ____.  a) Input b) Output c) Both (a) and (b) d) None of the above

The transformer which transforms unbalanced line to a balanced line is better known as  (A) Impedance transformer (B) Amplifier (C) Balun (D) Oscillator

A synchronous motor at no load condition is known as synchronous condenser and improves the (a) stability (b) efficiency (c) power factor (d) frequency of the integrated system

Materials having a high dielectric constant, which is non-linear are known as (a) Super dielectrics (b) Elastomers (c) Ferromagnetics (d) Hard dielectrics