A square matrix is called singular if its?

13 views
A square matrix is called singular if its?

A square matrix is called singular if its determinant is zero.

Related questions

A power system is represented by its system matrix ZBUS (m × m). Now an element is added in power system network without creating a new node. The dimension of the new impedance matrix will be (a) m × m (b) (m + 1) × (m + 1) (c) (m – 1) × (m – 1) (d) (m + 2) × (m + 2)

If a transformer primary is energised from a square wave voltage source, its output voltage will be a:  (A) square wave (B) sine wave (C) triangular wave (D) pulse wave

In the load flow analysis, a Jacobian is a matrix of size n × n with (A) constant elements (B) upper triangular constant elements (C) first partial derivative elements (D) second partial derivative elements

If a capacitance is charged by a square wave current source, then the voltage across the capacitor will be (a) Square wave (b) Step function (c) Triangular wave (d) Zero

A peak reading voltmeter has been calibrated with a sine wave signal and scaled in rms volts. If a square wave signal ± 1V peak is applied, the meter reading will be (a) 0.555 V (b) 0.707 V (c) 1 V (d) 1.75 V

A transformer has negative voltage regulation when its load power factor is   (1) Zero (2) Unity (3) Leading (4) Lagging

A long overhead transmission line is terminated by its characteristic impedance. Under this operating condition, the ratio of the voltage to the current at different points along the line will?

A voltage of 1000 kV is applied to an overhead line with its receiving end open. If the surge impedance of the line is 500 ohm, then the total surge power in the line ill

The impedance of a circuit is given by z=3+j4. Its conductance will be?

The IF is called as _________ A. initial flag B. indicate flag C. interrupt flag D. inter flag

If a computer on the network shares resources for others to use, it is called  (1) Server (2) Client (3) Mainframe (4) none

If a signal x(n)=x(–n), then it is called ____ signal. (1) Odd (2) Energy (3) Power (4) Even

The transmission line feeding power on either side of the main transmission line is called?

An 800 kV transmission line has a maximum power transfer capacity of P. If it is operated at 400 kV with the series reactance unchanged, the new maximum power transfer capacity is approximately (A) P (B) 2P (C) P / 2 (D) P / 4

If a voltage-controlled bus is treated as load bus, then which one of the following limits would be violated?   (a) Active power (b) Reactive power (c) Voltage (d) Phase angle

If the fault current is 2000 A, the relay setting is 50% and CT ratio is 400:5, the plug setting multiplier will be

If a line is 100 % series compensated it may result into series resonance at power frequency of?

What is the sag for a span of 400m, if the ultimate tensile strength of conductor is 6000 kgf, and the weight of conductor is 550 kgf/km? Factor of safety is 2.

A 100 km long transmission line is loaded at 110 kV.if the loss of line is 5 MW and the load is 150 MVA, the resistance of the line is?

The period of time between an allocation and its subsequent disposal is called  (1) scope (2) lifetime (3) longevity (4) dynamic binding

When The dc converter in figure shown has a resistance load of R = 10 Ω and the input voltage is Vs 220 V the converter switch remains on, its voltage drop is Vo -2 V. The chopping frequency is fI K sW Vs If the duty cycle is 50%, determine: (a) the average output voltage V (b) the RMS output voltage Vo (c) the converter efficiency (d) the effective input resistance of the converter

If Voltage Standing Wave Ratio, (VSWR) of a wave is 2, its reflection coefficient will be _____.

A circuit is said to be free from phase distortion if its phase response shows: (1) Quadrature variation with frequency (2) Independent of frequency (3) Linear variation with frequency (4) Proportional to frequency

A 3-phase induction motor is running at slip ‘s’. If its two supply leads are interchanged, then the operating slip at that instant will be:

If the diameter of a conductor of 10 ohms is doubled, its new resistance would be? A.20 ohms B.5 ohms C.40 ohms D.2.5 ohms

If the inertia constant H of a machine of 200 MVA is 2 p.u., its value corresponding to 400 MVA will be   (a) 4 p.u. (b) 2 p.u. (c) 1.0 p.u. (d) 0.5 p.u.

If a relay fails to operate for a fault within its reach, it is said to

If the insulation resistance of a cable of length 10 km is 1 mega ohm, its insulation resistance for 50 km length will be

If Poisson's ratio of a resistance wire strain gauge is 1.8, then neglecting piezo-resistive effects, its Gauge factor is :  (A) 2.8 (B) 2.6 (C) 4.6 (D) 3.6

In a superconductor, if the temperature is decreased below its critical temperature, the value of critical magnetic field will (a) Increase (b) Decrease (c) Not change (d) Increase or decrease depending on the superconductor material

If voltage at the two ends of a transmission line is 132 kV and its reactance is 40 Ohms, the capacity of the line will be: (A) 435.6 MW (B) 217.8 MW(C) 251.5 MW (D) 500 MW

One 200 V, 100 W bulb is connected in series with primary of a 200 V, 10 kVA transformer. If its secondary is kept open circuited, then the bulb would have (1) Full brightness (2) Poor brightness (3) A little less than full brightness (4) More than full brightness

A separately excited dc generator is running at rated speed and at no load. If its field winding is suddenly connected to a dc source then rise in armature generated voltage is governed by (1) Armature time constant (2) Field time constant (3) Both (a) and (b) (4) Mechanical time constant

A cumulative dc compound motor runs at 1500 rpm. on full load. If its series field is short-circuited, its speed  (1) becomes zero (2) remains unchanged (3) increases (4) decreases

A synchronous motor is delivering 80% of its rated output and is operating at UPF. If its excitation is increased, then  (1) the output delivered gets increased (2) its pf becomes lagging (3) the output delivered gets decreased (4) its pf becomes leading

If the back emf of a dc motor is doubled and its speed is also doubled, the torque developed in the machine will  (1) get doubled (2) become 4 times (3) get halved (4) remain unaltered

DC ammeter has a resistance of 0.1 Ω and its current range is 0-100 A. If the range is to be extended to 0-300 A, what shunt resistance need to be connected?  A) 0.025 Ω B) 0.05 Ω C) 0.015 Ω D) 0.03 Ω

If the load current and flux of a DC motor are held constant, and voltage applied across its armature is increased by 10%, its speed will:  (A) Decrease by 10%. (B) Remain unchanged. (C) Increase by 10%. (D) Increase by 20%.

If load on a d.c. shunt motor is increased, its speed is decreased due primarily to?

If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes?

Which of the following is true for a bus impedance matrix ?  (A) It is sparse  (B) It has diagonally dominant elements  (C) It is the inverse of the bus admittance matrix  (D) Each element of it is the reciprocal of the corresponding element in admittance matrix

For a 15-bus power system with 3 voltage controlled buses, the size of Jacobian matrix is

The p.u. parameter for a 500 MVA machine on its own base are: inertia, M = 20 p.u. ; reactance, X = 2 p.u. The p.u. values of inertia and reactance on 100 MVA common base, respectively, are (A) 4, 0.4 (B) 100, 10 (C) 4, 10 (D) 100, 0.4

A single phase transformer has resistance and reactance of 0.2 pu and 0.6 pu respectively. Its pu voltage regulation at 0.8 pf lagging would he