Can you help by answering this question?

Can we apply the superposition theorem to AC circuit?

22 views
in Electrical engineering materials by

Your answer

Thanks for your contribution. Feel free to answer this question. Please avoid short answer. Your answer is most welcome. Be genuine.

Upload image or document:

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
Are you a robot ? (Y = Yes / N = No)
To avoid this verification in future, please log in or register.

1 Answer

0 votes
by

The number of atoms per unit cell in B.C.C. structure is 2.

Related questions

1 answer 16 views

The co-ordination number of a simple cubic structure is

asked Mar 28, 2018 in Electrical engineering materials by Shimroz123
1 answer 24 views

The number of processes completed per unit time is known as ____________. (A) output (B) throughput (C) efficiency (D) capacity

asked Apr 23, 2018 in Computer Engineering by Shimroz123
0 answers 32 views

The number of processes completed per unit time is known as __________.  (1) Output (2) Throughput (3) Efficiency (4) Capacity

asked Apr 10, 2018 in Computer Engineering by Shimroz123
1 answer 233 views

Unit of frequency is ________________. A. Hz B. Horton C. dB D. Coulomb

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
1 answer 20 views

What are the number of valence electrons of atoms in semiconductor?

asked Mar 9, 2018 in Electrical Engineering by Quiz
1 answer 18 views

 Gauge factor of strain gauge is defined as the ratio of per unit change in the ______.

asked May 29, 2018 in Electrical Engineering by Shimroz123
1 answer 11 views

The tiny block formed by the arrangement of a small group of atoms is called the

asked Mar 28, 2018 in Electrical engineering materials by Shimroz123
1 answer 7 views

Unit of Power is_____________. A. Watt B. Joule C. Ampere D. Coulomb 

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
1 answer 11 views

The structure sensitive property of a super conductor is

asked Mar 28, 2018 in Electrical engineering materials by Shimroz123
1 answer 20 views

 If the number of branches in a network is 'B', the number of nodes is 'N' and the number of dependent loops is 'L', then the number of independent node equations will be  (a) N+L–1 (b) B–1 (c) B–N (d) N–1 

asked May 13, 2018 in Network Analysis by Shimroz123
1 answer 11 views

If Moor's law continues to hold, predict the approximation number of transistor per leading edge IC in the year. 1.2030 2.2050

asked Mar 21, 2018 in Unit 1 by Quiz
0 answers 23 views

The per unit impedance of a circuit element is 0.30. If the base kV and base MVA are halved, then the new value of the per unit impedance of the circuit element will be:  (A) 0.3 (B) 0.6 (C) 0.003 (D) 0.006 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 27 views

In dc choppers per unit ripple is maximum when duty cycle is   (a) 0.2 (b) 0.5 (c) 0.7 (d) 0.9

asked May 13, 2018 in Power Electronics by Shimroz123
0 answers 97 views

 When The dc converter in figure shown has a resistance load of R = 10 Ω and the input voltage is Vs 220 V the converter switch remains on, its voltage drop is Vo -2 V. The chopping frequency is fI K sW Vs If the duty cycle is 50%, determine: (a) the average output voltage V (b) the RMS output voltage Vo (c) the converter efficiency (d) the effective input resistance of the converter

asked Apr 26 by Hussein
1 answer 10 views

The formula ____ determines the number of electrons that can be accommodated in any level.

asked Mar 28, 2018 in Electrical engineering materials by Shimroz123
1 answer 15 views

 The number of parallel paths in the armature winding of a 4 -pole, wave connected d.c. machine having 28 coilside is : -  a) 28 b) 14 c) 4 d) 2

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
1 answer 17 views

The number of independent loops for a network with n nodes and b branches is

asked Apr 29, 2018 in Network Analysis by Shimroz123
0 answers 15 views

Voltages phasors at the two terminals of a transmission line of length 70 km have a magnitude of 1.0 per unit but are 180 degree out of phase. Assuming that the maximum load current in the line is 1/5th of minimum 3-phase fault current. Which one of the following transmission line protection schemes ... pick up at 1.25 times the maximum load current (C) Pilot relaying system with directional comparison scheme (D) Pilot relaying system with segregated phase comparison scheme

asked May 25, 2018 in Power system by Shimroz123
0 answers 430 views

The base kV and base MVA are halved and the per unit impedance new value is 0.5. The per unit impedance of the original circuit element is (A) 0.25 (B) 0.5 (C) 0.625 (D) 1.0 

asked Jun 4, 2018 in Power system by Shimroz123
1 answer 47 views

For a given base voltage and base volt-amperes, the per unit impedance value is x. For the doubled base values of both voltage and volt-amperes, the per unit impedance will be (a) 2x (b) 0.25x (c) 0.5x (d) no change 

asked May 25, 2018 in Battery by Shimroz123
1 answer 19 views

A 20-MVA, 6.6-kV, 3-phase alternator is connected to a 3-phase transmission line. The per unit positive-sequence, negative-sequence and zero-sequence impedances of the alternator are j0.1, j0.1 and j0.04 respectively. The neutral of the alternator is connected to ground through an inductive reactor of j0.05 p.u. The per unit positive-, ... The voltage of the alternator neutral with respect to ground during the fault is  (A) 513.8 V (B) 889.9 V (C) 1112.0 V (D) 642.2 V

asked May 25, 2018 in Power system by Shimroz123
1 answer 49 views

The per unit impedance ofa circuit element is 0.15. If the base kV and base MVA are halved, then the new value of the per unit impedance of the circuit element will be?

asked Mar 27, 2018 in Power system by Shimroz123
1 answer 65 views

Number of commutator bars for a 4-pole, 2-layer, DC lap winding with 24 slots and one conductor per layer is (A) 48 (B) 24 (C) 192 (D) 96

asked Apr 28, 2018 in Electrical Engineering by Shimroz123
1 answer 11 views

In air-core cable the surge voltage travels approximately at the speed of light and a cable of 100m length gives a delay of a. 0.666μsec b. 0.333μsec c. 1.555μsec d. 1μsec 

asked Sep 1, 2018 by Shimroz123
1 answer 27 views

In 8086 microprocessor , the address bus is ________ bit wide A. 12 bit B. 10 bit C. 16 bit D. 20 bit

asked Sep 28, 2018 in Microprocessors and Microcontrollers by Shimroz123
1 answer 18 views

Consider the star network shown in figure. The resistance between terminals A and B with C open is 6 ohms, between terminals B and C withAopen is 11 ohms and between terminals C andAwith B open is 9 ohms. Then RA, RB, RC respectively is 

asked May 20, 2018 in Network Analysis by Shimroz123
0 answers 15 views

The sequence in which the speed is increasing in ascending order  a. RAM  b. Hard disk  c. Cache  d. Thumb Drive/Memory Stick  (1) dbac (2) bdac (3) badc (4) abdc 

asked Apr 10, 2018 in Computer Engineering by Shimroz123
0 answers 17 views

Which of the following represents the valid integer number in 'C'?  A) 1500 B)1.1 C) 2-5 D) 0.123

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
1 answer 17 views

A d.c. potentiometer is designed to measure up to about 2V with a slide wire of 800 mm. A standard cell of emf 1.18V obtains balance at 600 mm. A test cell is seen to obtain balance at 680 mm. The emf0fthe test cell is  A)1.00V B)1.34V C)1.50V D)1.70V 

asked May 20, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 20 views

The OF is called as _______ A. overflow flag B. overdue flag C. one flag D. over flag 

asked Sep 28, 2018 in Microprocessors and Microcontrollers by Shimroz123
1 answer 24 views

The work of EU is ________ A. encoding B. decoding C. processing D. calculations 

asked Sep 28, 2018 in Microprocessors and Microcontrollers by Shimroz123
1 answer 8 views

If the no load voltage of a certain generator is 220V and the rated load voltage is 200V, then the voltage regulation is: a. 1% b. 10% c. 20V d. 9%

asked Sep 1, 2018 by Shimroz123
1 answer 15 views

Of the following, ____ is not a computer language. a) MS-Word b) C++ c) COBOL d) BASIC

asked May 13, 2018 in Computer Engineering by Shimroz123
1 answer 21 views

Of the following, ____ is different from the group.  a) Windows b) MS-Word c) MS-Excel d) MS-PowerPoint

asked May 13, 2018 in Computer Engineering by Shimroz123
1 answer 13 views

The following is correct : (A) P = V x I (B) P = I ² x R (C) P = V ² / R (D) All of the above

asked May 8, 2018 in Electrical Engineering by Shimroz123
1 answer 22 views

A transmission line of 200 km has a certain A, B, C and D parameters. If the length is reduced to 60 km

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 11 views

The output of an AND gate with three inputs, A, B and C, is HIGH when __________. a) A=1,B=1,C=0 b) A= 0,B= 0,C= 0 ' c) A=1,B=1,C=1 d) A=1,B= 0,C= 1

asked Apr 14, 2018 in Instrumentation and control by Shimroz123
1 answer 11 views

Which one is a vector quantity out of the followings?  A. Energy B. Volume C. Area D. Force

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
1 answer 13 views

Which of the following is not computer hardware? A. Printer B. CPU C. Monitor D. Antivirus  

asked Apr 12, 2018 in Computer Engineering by Shimroz123
1 answer 12 views

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,517 questions

7,115 answers

135 comments

3,090 users

...