Can you help by answering this question?

What is the use of Arduino Uno?

2,714 views
in Electrical Measurements and Instrumentation by
Which of the following instruments can be used to measure AC current only?

(a) Permanent Magnet Type ammeter(b) Induction type ammeter (c) Moving iron voltmeter(d) Moving iron ammeter

Your answer

Thanks for your contribution. Feel free to answer this question. Please avoid short answer. Your answer is most welcome. Be genuine.

Upload image or document:

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
Are you a robot ? (Y = Yes / N = No)
To avoid this verification in future, please log in or register.

1 Answer

0 votes
by
(b) Induction type ammeter

Related questions

1 answer 106 views

Which of the following can be used to measure the capacitance of a capacitor? A) Rheostat B) Schering bridge C) Wheatstone bridge D) None of these

asked Apr 29, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 12 views

Which of the following instruments can be used for measurement of very high value resistances such as insulation resistance in industries? A) Wheatstone bridge B) Megger C) Ohm-meter D) Resistive potentiometer 

asked Jun 17, 2018 in Electrical Measurements and Instrumentation by Shimroz123
0 answers 19 views

Which of the following instruments is equally accurate on ac as well as dc circuits ? (a) PMMC voltmeter (b) Dynamometer wattmeter (c) Moving iron ammeter (d) Induction wattmeter 

asked May 26, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 14 views

A VTVM can be used to measure (a) dc voltage only (b) ac voltage only (c) both (a) and (b) (d) None of the above 

asked May 26, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 9 views

Consider the following statements with regard to induction type wattmeter :  1. Can be used on both ac and dc systems.  2. Power consumption is relatively low.  3. It is accurate only at stated frequency and temperature.  Which of the above statements is/are correct ?  (a) 1 only (b) 2 only (c) 3 only (d) 1, 2 and 3

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 17 views

The power delivered to a 3-phase load can be measured by the use of two wattmeters only when the  (a) load is unbalanced (b) load is balanced (c) three phase load is connected to the source through three wires (d) three phase load is connected to the source through four wires

asked May 13, 2018 in Electrical Measurements and Instrumentation by Shimroz123
0 answers 19 views

The material of hair spring used in measuring instruments is made of which of material of the following : (a) Copper (b) Bronze (c) Alnico (d) None of these

asked May 26, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 18 views

Which of the following gates can be used to realize all possible combinational logic functions?  (i) OR gate (ii) NOR gate (iii) Exclusive OR gate (iv) NAND gate (v) AND gate  (A) (iii), (iv) and (v)  (B) (i), (iii) and (iv)  (C) (ii) and (iv)  (D) (i) and (v)

asked Apr 30, 2018 in Digital Electronics by Shimroz123
1 answer 18 views

A single transistor can be used to build which of the following digital logic gates : - a) AND gates b) OR gates c) NOT gates d) NAND gates

asked Apr 14, 2018 in Instrumentation and control by Shimroz123
1 answer 58 views

An unshielded moving iron voltmeter is used to measure the voltage in an AC circuit. The stray DC magnetic field having a component along the axis will be  (1) unaffected (2) decreased (3) increased (4) either decreased or increased depending on the direction of the DC field

asked Apr 29, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 24 views

Which of the following measure(s) is/are used to determine the quality of a printer ___.  a) Dots printed in a minute b) Dots per Inch c) Dot-Per-Square-Inch d) All of the Above

asked May 13, 2018 in Computer Engineering by Shimroz123
0 answers 32 views

Which of the following devices is used to measure flow in an open channel ?   (a) Venturimeter (b) Rota meter (c) Orifice (d) Pitot tube 

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
3 answers 90 views

What type of meter is used to measure current?

asked Mar 10, 2018 in Electrical Measurements and Instrumentation by Quiz
1 answer 55 views

Which of the following thyristors can be used for high frequency of operation? A) TRIAC B) DIAC C) SCR D) GTO 

asked Jun 18, 2018 in Thyristor by Shimroz123
1 answer 22 views

Which of the following transducers can be used for non-contact temperature measurement? A) Resistance temperature detector B) Thermistor C) Sensistor D) Pyrometer 

asked Jun 17, 2018 in Electronics Engineering by Shimroz123
1 answer 31 views

Which of the following instrument can be used for measuring speed of an aeroplane ? (A) orifice plate (B) hot wire anemometer (C) rotameter (D) pitot tube

asked Jun 15, 2018 in Mechanical Engineering by Shimroz123
1 answer 15 views

The 555 timer can be used in which of the following configurations ?  a) astable, monostable b) monostable, bistable c) astable, toggled d) bistable, tristable

asked Apr 14, 2018 in Instrumentation and control by Shimroz123
1 answer 40 views

Which of the following can be used as a primary memory? A) Magnetic Tape B) RAM C) Optical Disk D) Hard Disk

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
0 answers 19 views

Which of the following can be used as a primary memory?  A) Magnetic Tape B) RAM C) Optical Disk D) Hard Disk

asked Apr 9, 2018 in Computer Engineering by Shimroz123
1 answer 18 views

 Highest flux density exists inside which of the following instruments? A) Electrodynamic instruments B) Hot wire instruments C) Moving iron instruments D) Moving coil instruments

asked Jun 4, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 27 views

Eddy current damping is normally used in the instruments of (a) Induction type (b) Moving iron type (c) Permanent magnet moving coil type (d) Nothing can be said 

asked May 25, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 10 views

Which of the following theorems can be applied to any network linear or non-linear, active or passive, time variant or time invariant?   (a) Thevenin Theorem (b) Norton Theorem (c) Telligen Theorem (d) Superposition Theorem 

asked May 13, 2018 in Network Analysis by Shimroz123
1 answer 16 views

The power delivered to a three-phase load can be measured by the use of 2 wattmeter only when the A. Load is balanced B. 3 -phase load is connected to the source through 3 wires C. Load is unbalanced D. 3 -phase load is connected to the source through 4 wires

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
1 answer 30 views

Which of the following theorems enables a number of voltage (or current) source to be combined directly into a single voltage (or current) source. (1) compensation theorem (2) reciprocity theorem (3) superposition theorem (4) Millman's theorem

asked Apr 29, 2018 in Network Analysis by Shimroz123
1 answer 27 views

Which of the following motors can run on both AC and DC? A) Universal motor B) Dual wattage motor C) Flexible motor D) All the above

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 19 views

TRIAC is an ac switch which can be made to conduct on

asked May 23, 2018 in Power Electronics by Shimroz123
0 answers 7 views

Which of the following statements pertains to resistors only ?   (a) They oppose sudden change in voltage. (b) They can act as energy storage device. (c) They can dissipate desired amount of power. (d) None of the above. 

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
0 answers 17 views

Which command will be used to view the contents of the directory of the current disk drive?  (1) list (2) dir (3) cd (4) tree

asked Apr 10, 2018 in Computer Engineering by Shimroz123
2 answers 64 views

The bridge used to measure the dielectric loss of an insulator is: A) Anderson bridge B) Wien’s bridge C) Schering bridge D) Any of the above

asked Jun 4, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 19 views

Which three-phase connection can be used in a transformer to introduce a phase difference of 30o between its output and corresponding input line voltages  (A) Star-Star (B) Star-Delta (C) Delta-Delta (D) Delta-Zigzag

asked May 17, 2018 in Transformer by Shimroz123
1 answer 24 views

Thermocouple instruments can be used for a frequency range upto   (a) 100Hz (b) 5000 Hz (c) 1 MHz (d) 50 MHz and above 

asked May 13, 2018 in Instrumentation and control by Shimroz123
19 answers 99 views

Moving iron instruments can be used for measuring (1) Direct currents and voltages (2) Radio frequency currents (3) A.C currents and voltages (4) Both (a) and (c)

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
1 answer 41 views

How can a magnetic field be used to generate an electric current?

asked Mar 10, 2018 in Engineering electromagnetic by Quiz
1 answer 14 views

Which of the following can reduce the Eddy current losses? A) By making the core of a stack of plates electrically insulated from each other B) By making the core of solid block C) By increasing the applied voltage  D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 16 views

The speed and torque of induction motors can be varied by which of the following means: 1) Stator voltage control 2) Rotor voltage control 3) Frequency control 4) All of these

asked Jun 4, 2018 in Induction Machine by Shimroz123
1 answer 17 views

Of the following, ____ would be considered as a way through which a computer virus can enter into a computer system.  a) E-mail with attachments b) Downloading the data from sites c) Operating the system without antivirus software d) All of the above

asked May 13, 2018 in Computer Engineering by Shimroz123
0 answers 17 views

Which of the following permutation can be obtained in the output (in the same order) using a stack assuming that the input is the sequence 1, 2, 3, 4, 5 in that order?  (1) 3, 4, 5, 1, 2 (2) 3, 4, 5, 2, 1 (3) 1, 5, 2, 3, 4 (4) 5, 4, 3, 1, 2 

asked Apr 10, 2018 in Computer Engineering by Shimroz123
0 answers 21 views

Which of the following can‟t be declared static?  (1) Member variables (2) Object (3) functions (4) none of these

asked Apr 10, 2018 in Computer Engineering by Shimroz123
0 answers 14 views

By which of the following connections, one-bit binary counter can be obtained from a JK flip-flop?  A) J = K = 0 B) J = K = 1 C) J = K’ D) None of these

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
2 answers 55 views

An Auto-transformer (which has only one winding) may be used as a ______ .  (A) Both Step-Up and Step-Down transformer (B) Step-Down Transformer (C) Step-Up Transformer (D) None of these

asked May 8, 2018 in Electrical Engineering by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,471 questions

7,069 answers

134 comments

3,088 users

...