In a gravity controlled instrument, the deflection angle is proportional to

12 views

In a gravity controlled instrument, the deflection angle is proportional to sine inverse of measurand.

Related questions

In a particular meter, the deflecting torque is directly proportional to the current flowing through it, the type of meter is (a) moving coil (b) moving iron (c) induction (d) electro-static

A moving coil instrument has a resistance of 10 W and gives full scale deflection when carrying a current of 50 mA. To measure current upto 100 A, we will have to connect • 10 W resistance in series • 10 W resistance in parallel • 10/1999 W resistance in series • 10/1999 W resistance in parallel

The torque produced in wattmeter is proportional to

In a galvanometer, the deflection becomes one half when the galvanometer is shunted by a 20 ohm resistor. The galvanometer resistance is

In the case of an instrument reading of 8.3 V with a 0 to 150 voltmeter having a guaranteed accuracy of 1% full scale reading, the percentage limiting error is   (A) 1.810% (B) 0.181% (C)12.45% (D) 0.0018%

Which of the following factors limit the deflection of the pointer of a PMMC instrument of about 90o?  1. Its damping mechanism  2. Linearity of magnetic field in which the coil moves  3. Control spring arrangement  4. Shape of pole shoe for the horse shoe magnet   Select the correct answer using the code given below:   (a) Only 1 and 3 (b) Only 2 and 4 (c) Only 2 and 3 (d) Only 1 and 4

In a PMMC instrument, the damping provided is :  (A) air damping (C) eddy current damping (B) fluid damping (D) magnetic damping using a magnet

A single-phase fully controlled thyristor bridge ac-dc converter is operating at a firing angle of 25o and an overlap angle of 10o with constant dc output current of 20 A. The fundamental power factor (displacement factor) at input ac mains is  (A) 0.78 (B) 0.827 (C) 0.866 (D) 0.9

A single phase fully controlled thyristor bridge ac -dc converter is operating at a firing angle of 25 degree and an overlap angle 10 degree with constant dc output current of 20A. The fundamental power factor (displacement factor) at input ac mains is : (A) 0.78 (B) 0.827 (C) 0.866 (0) 0.9

When the firing angle a of a single-phase, fully controlled rectifier feeding constant direct current into a load is 30°, the displacement power factor of the rectifier is

A Pyrheliometer is an instrument to measure :  (A) temperature of solar photovoltaic cell  (B) intensity of direct solar radiation at normal incidence  (C) intensity of indirect solar radiation  (D) efficiency of a solar photovoltaic cell

A PMMC instrument has FSD of 100 μA and a coil resistance of 1 kΩ. To convert the instrument into an ammeter with full scale deflection of 100 mA, the required shunt resistance is (A) 1 Ω (B) 1.001 Ω (C) 0.5 Ω (D) 10 Ω

A Voltage Controlled Oscillator (VCO) is an instrument : - a) whose frequency is dependent upon the amplitude of input signal b) whose frequency is independent upon the amplitude of input signal c) whose frequency is dependent upon the frequency of input signal d) none of the above

The moving system of an indicating type of electrical instrument is subjected to (a) a deflecting torque (b) a controlling torque (c) a damping torque (d) All of the above

To a highly inductive circuit, a small capacitance is added in series. The angle between voltage and current will _____.

The phase angle corresponding to λ/4 in a standing– wave pattern is: (1) 30° (2) 90° (3) 135° (4) 180°

What happens to the angle between current and voltage, when a small capacitance is added in series with a highly inductive circuit?  (A) Increases (B) Remains same as earlier angle (C) Decreases (D) Becomes indeterminant

The resolved part of the resultant of two forces inclined at an angle 9 in a given direction is equal to

A separately excited dc motor is required to be controlled, from a 3-phase supply, for its operation in the first quadrant only. The most preferred converter would be  (a) 3-phase fully controlled converter (b) 3-phase fully controlled converter with free wheel diode (c) 3-phase dual converter (d) 3-phase half wave converter

A 0-10 A ammeter has a guaranteed accuracy of 1% of full scale deflection, the limiting error while reading 2.5 A will be (a) 1% (b) 2% (c) 4% (d) None of these

The full-scale deflection current of an ammeter is 1 mA and its internal resistance is 100Ohm. This is to have full deflection when 100V is measured. What is the value of series resistor to be used?

The full-scale deflection current of an ammeter is 1 mA and its internal resistance is 100Ohm. If this meter is to have full deflection at 5A, what is the value of the shunt resistance to be used?

Series resistance required to read 0-250 V with a moving coil instrument of internal resistance 2 ohm and full scale deflection of 50 mA is (a) 49998 Ω (b) 4998 Ω (c) 498 Ω (d) 49.8 Ω

A null type of instrument as compared to a deflecting type instrument has (a) higher accuracy (b) lower sensitivity (c) faster response (d) All of the above

If the distance of screen from a CRT to center of deflection plates is 15 cm, the length of deflection plates is 2 cm, the distance between the plates is 1 cm and accelerating voltage is 500 V, deflection sensitivity is   (a) 33.2 V/cm (b) 0.03 cm/V (c) 66.4 V/cm (d) 0.015 cm/V

The vertical deflection of an electron beam on the screen of a CRO is measured to be 8 mm. Now, the potential difference between the Y-plates is doubled, and simultaneously the pre-accelerating anode voltage is reduced to half of its previous value. Then, the vertical deflection of the beam on the screen would become (A) 64 mm (B) 32 mm (C) 8 mm (D) 1 mm

Power in the wind is proportional to

The torque, in a_______ is proportional to the square of the armature current. (A) DC shunt motor (C) 2 -phase servomotor (B) stepper motor (D) DC series motor