Engineering
Login
Register
Search
Topics/Subjects
Ask a Question
Install App
Intrinsic impedance of free space is given as
asked
in
Electronics Engineering
by
QuestionAnswer
Please
log in
or
register
to add a comment.
← Prev Question
Next Question →
Please
log in
or
register
to answer this question.
1 Answer
Intrinsic impedance of free space is given as
377 ῼ.
answered
by
QuestionAnswer
Please
log in
or
register
to add a comment.
Advertisements
Related questions
Substances which have permeability less than the permeability of free space are known as
State the values of permeability of free space and relative permeability of air.
In a single crystal of an intrinsic semiconductor, the number of free carriers at the Fermi level at room
In an intrinsic semiconductor, the number of free electrons ………
Compare indoor and outdoor sub-station on given points : (i) Capital cost (ii) Time required for completion (iii) Availability of natural light (iv) Space required
The impedance of a circuit is given by z=3+j4. Its conductance will be?
For a given base voltage and base volt-amperes, the per unit impedance value is x. For the doubled base
Calculate the size of memory address space for a 16 bit data and 20 bit address bus.
What is the ratio of resistance and impedance better known as ?
A single-phase full-bridge diode rectifier delivers a load current of 10A, which is ripple free.
At absolute zero temperature, an intrinsic semiconductor behaves as
At room temperature, an intrinsic silicon crystal acts approximately as ……
The rated voltage of a 3-phase power system is given as
The error of an instrument is normally given as a percentage of
The lossless line of characteristics impedance 300 Ohm is terminated in a pure resistance of 200 Ohm.
If the RF transmission is terminated in its Characteristic impedance Z, which of the following statements is...
A loss less line of characteristic impedance Z0 is terminated in pure reactance of –jZ0 value. VSWR is
The surge impedance for over head line is taken as
A circuit is said to be free from phase distortion if its phase response shows:
Identify type of BJT configuration having following features : (i) BJT configuration having the least current gain. (ii) KIT configuration called as voltage follower. (iii) BJT configuration having current gain less than one. (iv) BJT configuration suitable for impedance matching. (v) BIT configuration suitable for voltage amplification. (vi) BJT configuration having the least output impedance.
n-type semiconductor can be made by adding ____ to intrinsic semiconductor
Minimum number of bits required to represent maximum value of given analogue signal with 0.1% accuracy is:
The response of an LTI/LSI system is given by the _______ of input and impulse response:...
The shunt admittance of a transmission line is given by
When sine wave is given as input to Schmitt trigger then it generates :
A four bit number is given as 0110. Its 2’s complement is
As hysteresis motors are free from mechanical and magnetic vibrations therefore these are considered as suitable for?
RTL Design: Convert the given C code to a High-Level State Machine (Draw HLSM diagram). Do not optimize or change the code, simply convert as provided.list all local storage (including its size (number of bits)) that you plan to use with your HLSM.
The current carried by a given type of ion expressed as a fraction of total current conducted
The hysteresis loop of magnetic material has an area of 5 cm2 with the scales given as...
Maximum power is transferred when load impedance is ...
Among the three configuration the highest output impedance is obtained by
Typical loudspeaker impedance rating is
In an RLC parallel circuit, the impedance at resonance is
The magnitude of the open-circuit and short circuit input impedance of a transmission line are 100 ohm and...
The fastest logic family among the below given ones is...
UHF band is given by
The phase voltages across a certain load are given as...
Intrinsic semiconductor material is characterized by a valence shell of how many electrons?
Which design method is based on state space approach?
In D.C. generators on no-load, the air gap flux distribution in space is?
inductors have a high impedance when?
The synchronous speed for the seventh space harmonic mmf wave of a 3-phase, 8-pole, 50 Hz induction
Explain space vector transformation and space vector switching with the help of diagram.
The time constant of an RC circuit is defined as the time taken by the voltage across the
The microwave device working on the principal of Faraday rotation is called as:
As the wave frequency approaches to cut-off frequency of wave guide, the correct statement is :
A 339 IC is an example of a fourteen-pin DIP that can be made to function as a ________:
Which of the following is used as a data selector?
The difference between the indicated value and the true value of a quantity is known as