Ask a Question
If a wave has frequency of 2 Hz, it has a period of ?
to add a comment.
← Prev Question
Next Question →
to answer this question.
If a wave has frequency of 2 Hz, it has a period of
to add a comment.
When a sine wave has a frequency of 100 Hz in 12 s it goes through?
A sine wave has a frequency of 50 Hz. Its angular frequency is _______ radian/second.
A series R-L-C Circuit has a resonant frequency of 1000 Hz. If the values of R, L and C are
For a frequency of 200 Hz, the time period will be?
When The dc converter in figure shown has a resistance load of R = 10 Ω and the input voltage is Vs 220 V the converter switch remains on, its voltage drop is Vo -2 V. The chopping frequency is fI K sW Vs If the duty cycle is 50%, determine: (a) the average output voltage V (b) the RMS output voltage Vo (c) the converter efficiency (d) the effective input resistance of the converter
A square wave has a period of 60 s. The first odd harmonic is:
In a full wave rectifier with input frequency of 50 Hz, the frequency of the output is:
The input frequency is 50 Hz. The ripple frequency in a 12 phase full wave rectifier is
A rectangular waveguide is 4.2 cm by 1.85 cm. The cut-off frequency of the dominant mode through this
Define: 1) frequency, 2) cycle, 3) time period, 4) amplitude
The reactance offered by a capacitor to an alternating current of frequency 50 Hz is 10 ohm. If frequency is
A tuned circuit has a Q of 100 at its resonant frequency of 500 kHz. Its bandwidth is _____kHz.
In the telephone, the dial tone has a frequency of
In a radio transmitter, the frequency of the crystal oscillator will be stable for a long time if the quality factor
In a half-wave rectifier, if an a.c supply is 60 Hz. Then what is the a.c ripple at output?
An OP amp has a slew rate of 1V/µs. At a signal frequency of 0.1 MHz, the maximum undistorted sine wave ...
If frequency is decreased 4 times, then skin depth of an Electromagnetic wave inside a conductor will be : ...
If Voltage Standing Wave Ratio, (VSWR) of a wave is 2, its reflection coefficient will be _____.
What would happen if a power transformer designed for operation on 50 Hz (frequency) were connected to
A 50 Hz, 4 pole turboalternator rated at 20 MVA. 13.2 KV has an inertia constant H = 4 KW sec/KVA.
A high-pass filter has a resistance R = 2 kΩ The lowest input frequency to be passed is 7.5 kHz. The value of
A material has conductivity of 10–2 mho/m and relative permittivity of 4. The frequency at which the
A system has 14 poles and 2 zeros in its open -loop transfer function. The slope of its highest frequency ...
A Lissajous pattern on an oscilloscope has 5 horizontal tangencies and 2 vertical tangencies. The frequency of...
A relay has a rating of 5 A, 2.2 sec IDMT and a relay setting of 125% TMS = 0.6. It is connected to a supply
lf a travelling-wave travelling along a loss-less overhead line does not result in any reflection after it has
An accelerometer has input range of 0 to 10g, natural frequency 30 Hz and mass 0.001 kg. The range of the
If transformer frequency is changed from 60 Hz, to 60 Hz the ratio of...
RMS value of rectangular wave of period T, having a value of +V for a duration T1(<T) and -V for the duration...
The period of a wave is?
For an antenna to be frequency-independent, it should expand or contract in proportion to the
A pulse radar has a pulse repetition frequency (PRF) of 3 KHz. If the radar is emitting at 10 GHz, what is the
A series RLC circuit has a resonant frequency of 1 KHz and a quality factor Q = 100. If each of the R,L and C...
An 800 kV transmission line has a maximum power transfer capacity of P. If it is operated at 400 kV with the
A radioactive isotope has a half-life of 10 days. If today there are 125 g of it left, what was its original weight...
A cable has an insulation of relative permittivity 2. If the insulation is replaced by one of relative permittivity
A peak reading voltmeter has been calibrated with a sine wave signal and scaled in rms volts. If a square wave
A high pass filter has a resistance R = 2 kΩ. The lowest input frequency to...
In a pure capacitive circuit if the supply frequency is reduced to 1/2, the current will?
In a pure inductive circuit if the supply frequency is reduced to 1/2, the current will?
(a) Define permeability. (b) Define MMF. (c) Define form factor of an alternating quantity. (d) Define frequency and time period of an alternating quality. (e) Define transformation ratio of transformer. (f) State the EMF equation of a 1 transformer and state the meaning of each term used. (g) Give two applications of single phase motors.
if voltage is 230 Volts , frequency is 50 Hz and current is 1 ampere then what will be the resistance?
What is the frequency of an alternator which has 2 poles and makes 3600 revolutions per minute?
The step angle of the stepper motor is 2.5°. If the stepping frequency is 3600 pulses per second, then the ...
Define : i) Amplitude ii) Frequency iii) Time period iv) Angular velocity related to a.c.
The synchronous speed for the seventh space harmonic mmf wave of a 3-phase, 8-pole, 50 Hz induction
The equation of 50 Hz current sine wave having r.m.s. value of 60 A is?
A sinusoidal voltage of 5 Hz is applied to the field of a shunt generator. The armature voltage wave?
The period corresponding to 50 Hz power supply is
The time period of third harmonic of power supply frequency, in milliseconds, is