# The force between two long parallel conductors is inversely proportional to

15 views

The force between two long parallel conductors is inversely proportional to distance between the conductors.

## Related questions

Two long parallel conductors carry 100 A. If the conductors are separated by 20 mm, the force per meter of length of each conductor will be

The IF BW of a radar receiver is inversely proportional to the (A) Pulse width (B) prf (C) Pulse interval (D) Square root of the peak transmitted frequency

The force acting between two magnetic poles is

Which of the statements about the force between two charge is true?  (1) Unlike charges repel each other (2) Like charges attract each other (3) No force exists between two unlike charges (4) A force of repulsion exists between two like charges

When the separation between two charges is made four times, the force between them  (a) increases four times (b) decreases four times (c) increases sixteen times (d) decreases sixteen times

Two parallel conductors are separated by a distance, d carrying a current, I in the same direction. The magnetic field along a line running parallel to the conductors and midway between them is (A) zero (B) proportional to I (C) proportional to d (D) proportional to the permeability of the medium.

The conductors have transport phenomena of electrons due to

How much is the potential difference between two points if 0.5 J of energy is required to move 0.4 C of charge between the two points?

When the phase difference between two sinusoidal quantities is 90° they are said to be ______ A) Phase right angle B) Phase quadrature C) Phase sinuright D) None of these

The distance between two coil sides which are connected to the same commutator segment is called as  (1) winding pitch (2) back pitch (3) front pitch (4) full pitch

Which of the following test is carried out to ensure the sufficient strength of insulation between two or more conductors to avoid leakage between them ?   (a) Testing of insulation resistance between wiring and earth (b) Testing of insulation resistance between conductors (c) Testing of polarity of single phase switch (d) Testing of earth continuity path

A 300 mm long conductor is carrying a current of 10 A and is situated at right angles to a magnetic field having a flux density of 0.8 T ; the force on the conductor will be

When two synchronous machines are connected in parallel the synchronizing power tends to (A) accelerate the faster machine (B) retard the faster machine (C) retards the slower machine (D) pull the faster machine out of step

When two transformer of different kVA rating are connected in parallel they share the load in proportion to their respective kVA rating only when their:

Two transformers with identical voltage ratings are working in parallel to supply common load. The percentage impedance of one transformer is higher compared to that of other. The load sharing between the two transformer will: (1) Be proportional to their percentage impedance (2) Be independent of their percentage impedance (3) Be inversely proportional of their respective impedance (4) Depend on the resistance to leakage reactance ratio of each transformer

When two alternators A and B are operating in parallel, the increase in steam supply to alternator A will cause the active power output of (1) Alternator A to be decreased and alternator B to be increased (2) Alternators A and B is not affected (3) Alternators A and B is increased (4) Alternator A to be increased and alternator B to be decreased

Two 550 kVA alternator operate in parallel to supply the following loads I. 250 KW at 0.95 p.f. lagging II. 100 KW at 0.85 p.f. leading One machine is supplying 200 KW at 0.9 p.f. lagging. The p.f. of other machine must be

Two copper conductors have equal length. The cross-sectional area of one conductor is four times that of the other. If the conductor having smaller cross-sectional area has a resistance of 40 ohms the resistance of other conductor will be?

Twelve 1 ohm resistances are used as edge to form a cube. The resistance between two diagonally opposite corners of the cube is:  (1) 5/6 ohm (2) 1 ohm (3) 6/5 ohm (4) 3/2 ohm

If the spacing between the conductors increases, the corona effect

The conductor of a 10 km long, single phase, two wire line are separated by a distance of 1.5 m. The diameter of each conductor is 1 cm, If the conductors are of copper, the inductance of the circuit is

Two transformers are to be operated in parallel such that they share load in proportion to their kVA ratings. The rating of the first transformer is 500 kVA ratings. The rating of the first transformer is 500 kVA and its pu leakage impedance is 0.05 pu. If the rating of second transformer is 250 kVA, its pu leakage impedance is  (A) 0.20 (B) 0.10 (C) 0.05 (D) 0.025

A 36 slot, 4 -pole, dc machine has a simplex lap winding with two conductors per slot. The back pitch and front pitch adopted could be respectively

Two aluminium conductors have equal length. The cross-sectional area of one conductor is four times that of the other. If the conductor having smaller cross-sectional area has a resistance of 100 ohms the resistance of other conductor will be

If two 3-phase transformers with unequal voltage ratios are connected in parallel, the result is (A) circulating current on no-load (B) no circulating current on no-load (C) dead short-circuit (D) equal no-load secondary emfs

The condition for parallel operation of two inverters is • Amplitude of voltages should be same. • Frequency of voltages should be same. • Both the voltages should be in same phase. • All the three above.

When two alternators are operating in parallel, the cause for circulating current is (A) increase in the excitation of one machine (B) increase in the driving torque of one machine (C) reduction in angular velocity of one machine (D) identical speed/load characteristics of both machines

In a particular meter, the deflecting torque is directly proportional to the current flowing through it, the type of meter is (a) moving coil (b) moving iron (c) induction (d) electro-static

The capacitance of the capacitor is directly proportional to the

Power in the wind is proportional to

The torque produced in wattmeter is proportional to

The torque, in a_______ is proportional to the square of the armature current. (A) DC shunt motor (C) 2 -phase servomotor (B) stepper motor (D) DC series motor