# Two long parallel conductors carry 100 A. If the conductors are separated...

17 views

Two long parallel conductors carry 100 A. If the conductors are separated by 20 mm, the force per meter of length of each conductor will be

Two long parallel conductors carry 100 A. If the conductors are separated by 20 mm, the force per meter of length of each conductor will be 0.1 N.

## Related questions

Two parallel conductors are separated by a distance, d carrying a current, I in the same direction. The magnetic field along a line running parallel to the conductors and midway between them is (A) zero (B) proportional to I (C) proportional to d (D) proportional to the permeability of the medium.

The conductor of a 10 km long, single phase, two wire line are separated by a distance of 1.5 m. The diameter of each conductor is 1 cm, If the conductors are of copper, the inductance of the circuit is

Three lamps are connected in parallel across a 120 Volt source. If one lamp burns out, the remaining two will be: A. Glow dimmer B. Glow brighter C. Not light D. Glow with the same brightness as before

A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is: (1) 4000 Ω (2) 400 Ω (3) 40 Ω (4) 4 Ω

A 100 km long transmission line is loaded at 110 kV.if the loss of line is 5 MW and the load is 150 MVA, the resistance of the line is?

When two 100 kΩ resistors are connected in parallel, net resistance is

If two 3-phase transformers with unequal voltage ratios are connected in parallel, the result is (A) circulating current on no-load (B) no circulating current on no-load (C) dead short-circuit (D) equal no-load secondary emfs

If shunt generator delivers 100 A at 200 V, and the resistance of the shunt field and armature are 100 ohm and 0.01 ohm respectively, the generated e.m.f. will be : -  a) 212 V b) 205 V c) 210 V d) 201.02 V

The fast carry or look-ahead carry circuits found in most 4-bit parallel-adder circuits:  (1) Increase ripple delay (2) Add a 1 to complemented inputs (3) Reduce propagation delay (4) Determine sign and magnitude

When two alternators A and B are operating in parallel, the increase in steam supply to alternator A will cause the active power output of (1) Alternator A to be decreased and alternator B to be increased (2) Alternators A and B is not affected (3) Alternators A and B is increased (4) Alternator A to be increased and alternator B to be decreased

The induced emf in the armature of a wave wound 4-pole d.c. machine having 100 armature conductors rotating at 600 r.p.m. and with a flux of 1 Wb per pole is (a) 1000 V (b) 2000 V (c) 200 V (d) 100 V

The induced emf in the armature of a lap -wound four -pole dc machine having 100 armature conductors rotating at 600 rpm and with 1 Wb flux per pole is  (1) 1000V (2) 100V (3) 600V (4) 10,000V

A long wire carrying 100 amp is placed in an external magnetic field of 50 gauss. The wire is at right angles to the field.

Two d.c. series motors connected in series are driving a mechanical load. If the motors are connected in parallel to drive the same load, the speed becomes  (a) slightly less than double (b) slightly less than half (c) slightly more than double (d) slightly more than half

In CRO, Lissajous pattern will be a straight line, if the two signals are of same frequency with a phase difference of (a) 0° (b) 180° (c) 360° (d) All of these

A 3-phase induction motor is running at slip ‘s’. If its two supply leads are interchanged, then the operating slip at that instant will be:

When two synchronous machines are connected in parallel the synchronizing power tends to (A) accelerate the faster machine (B) retard the faster machine (C) retards the slower machine (D) pull the faster machine out of step

How will the total capacitance change, when two capacitors are connected in parallel?

Two heater wires of equal length are connected first in series and then in parallel. The ratio of heat generated from series to parallel connection will be (a) 4 : 1 (b) 2 : 1 (c) 1 : 2 (d) 1 : 4

When two transformer of different kVA rating are connected in parallel they share the load in proportion to their respective kVA rating only when their:

Two transformers with identical voltage ratings are working in parallel to supply common load. The percentage impedance of one transformer is higher compared to that of other. The load sharing between the two transformer will: (1) Be proportional to their percentage impedance (2) Be independent of their percentage impedance (3) Be inversely proportional of their respective impedance (4) Depend on the resistance to leakage reactance ratio of each transformer

When two alternators are operating in parallel, the cause for circulating current is (A) increase in the excitation of one machine (B) increase in the driving torque of one machine (C) reduction in angular velocity of one machine (D) identical speed/load characteristics of both machines

A 300 mm long conductor is carrying a current of 10 A and is situated at right angles to a magnetic field having a flux density of 0.8 T ; the force on the conductor will be

Two 3-phase transformers cannot be operated in parallel, if their :  (A) kVAs are different (B) phase sequences are different (C) % impedances are different (D) voltage ratios are different

Three 60 W bulbs are in parallel across the 230 V power line. If one bulb burns out

Three 60 W bulbs are in parallel across the 60 V power line. If one bulb burns open?

In a radio transmitter, the frequency of the crystal oscillator will be stable for a long time if the quality factor of the crystal resonator is  (a) > 100 (b) > 500 (c) > 1000 (d) > 20000

A 36 slot, 4 -pole, dc machine has a simplex lap winding with two conductors per slot. The back pitch and front pitch adopted could be respectively

Bandwidth of an RC coupled amplifier is 100 kHz. Two such amplifiers are connected in cascade.Resultant bandwidth(in kHz) is around  A) 200 B) 100 C) 60 D) 30

Two bulbs marked 200 watt-250 volts and 100 watt-250 volts are joined in series to 250 volts supply. Power consumed in circuit is

The conductors have transport phenomena of electrons due to

Polyphase generators produce simultaneous multiple sinusoidal voltages that are separated by certain constant: A. Phase -angles B. Frequency C. Voltage D. Current

Two transformers are to be operated in parallel such that they share load in proportion to their kVA ratings. The rating of the first transformer is 500 kVA ratings. The rating of the first transformer is 500 kVA and its pu leakage impedance is 0.05 pu. If the rating of second transformer is 250 kVA, its pu leakage impedance is  (A) 0.20 (B) 0.10 (C) 0.05 (D) 0.025

Two synchronous generators G1, G2 are operating in parallel and are equally sharing KVAR (Lag) component of load. To shift part of KVAR from G2 to G1, while keeping terminal voltage fixed, the following action must be done

In the measurement of three phase power by two wattmeter method, if the two wattmeter readings are equal then power factor of the circuit is  (A) 0.8 lag (B) Unity (C) 0.8 lead (D) Zero