# The initial permeability of an iron rod is

15 views

The initial permeability of an iron rod is the permeability almost in non-magnetised state.

## Related questions

When the initial slope of input sine wave is greater than the slew rate of an OPAMP, the output: (1) Has no offset (2) Approaches to triangular waveshape (3) Is pure sinusoidal (4) Is square wave

An iron ring of mean circumference 80 cm is uniformly wound with 500 turns of wire and carries 0.8A. Find the magnetic field strength.

The effective resistance of an iron-cored choke working on ordinary supply frequency is more than its true resistance because of?

An unshielded moving iron voltmeter is used to measure the voltage in an AC circuit. The stray DC magnetic field having a component along the axis will be  (1) unaffected (2) decreased (3) increased (4) either decreased or increased depending on the direction of the DC field

When the initial conditions of a system are specified to be zero it implies that the system is?

An inductor at t = 0+ with zero initial conditions acts as   (a) short circuit (b) open circuit (c) current source (d) voltage source

Which type of earthing is also called as 'fire earthing'? A. Plate earthing B. Rod earthing C. Strip earthing

State the function of following components of a nuclear power station: i) Moderator ii) Shielding iii) Control rod iv) Coolant

The center of percussion of the homogeneous rod of length L suspended at the top will be?

An iron cored inductance coil can be modelled, over a normal operating range of networks ,as A) non-Linear bilateral element B) linear bilateral element C) linear time varying element D) non-linear time invariant element

One 200 KVA transformer has an iron loss of 1 KW and full load Cu loss of 2 KW. Its load KVA corresponding to maximum efficiency is:  (A) 100 KVA (B) 141.4 KVA (C) 50 KVA (D) 200 KVA

The permeability of a diamagnetic material is  1. Zero 2. Less than 1 3. Equal to 1 4. More than 1

The magnetic permeability of a diamagnet is _________ A) More than that of vacuum B) Same as that of vacuum C) Less than that of vacuum D) 3.14 times that of vacuum

The relative permeability of a ferromagnetic material is?

Permeability in a magnetic circuit corresponds to______ in an electric circuit.

Solder is an alloy of?

Explain the concept of initial and final conditions in switching for L and C.

Which of the following power plants involves high initial cost in erecting?  (A) Hydro-electric power plant (B) Steam power plant (C) Gas turbine power plant (D) Nuclear power plant

The initial rate of rise of current through a coil of inductance 10 H when suddenly connected to a D.C. supply of 200 V is_______Vs.

The IF is called as _________ A. initial flag B. indicate flag C. interrupt flag D. inter flag

The initial response when the output is not equal to input is called?

A glass rod when rubbed with silk cloth is charged because?

The electrode rod used for welding uses a coating on it

A transformer has maximum efficiency at 3/4 full load. The ratio of its iron losses and full load copper loss is : -  a) 16/9 b) 4 / 3 c) 3/4 d) 9 /16

An electric iron designed for 110V AC supply was rated at 500W. It was put across a 220V supply. Assuming that at 110V it supplied 500W output (i.e no losses) at the new voltage it will supply  a. 2500W b. 250W c. 500W d. 2000W

A ferrite core has less eddy current loss than an iron core because?