# How many different combinations may be obtained with three resistors, each having the resistance R ?

25 views

4 different combinations may be obtained with three resistors, each having the resistance R.

## Related questions

What is the equivalent resistance of a network having 5 resistors of each 10ohm connected in parallel?  (A) 10 Ohms (B) 50 Ohms (C) 500 Ohms (D) 2 Ohms

Which of the following is true with a series circuit having resistors of different values? A) The total resistance of the circuit is the sum of the individual resistances B) The current across each resistor is the same C) The voltage drop across each resistor depends on the value of the resistor D) All the above

what will be the capacitance if three capacitors connected in parallel each having value of 0.5 micro Farad ?

About how many times longer would a 10 watt light bulb be able to burn compared to a 100 watt bulb with the same energy?  (A) 10 times longer (B) 100 times longer (C) Same time (D) None of the above

Which of the following series combinations of resistors dissipates the most power when connected across a 120 V source? A. One, 220Ω resistor B. Two, 220Ω resistors C. Three, 220Ω resistors D. Four, 220Ω resistors

A balanced Delta connected load supplied with 440 V 50 Hz three phase AC supply has R=10 Ohm and L=0.6 mH in is each arm. Calculate line and phase current, active power.

What is the total resistance if 5 resistors of 20 Ω each are connected in series? A) 100 Ω B) 4 Ω C) 20 Ω D) None of these

A conductor is composed of seven identical copper strands, each having a radius 'R'. Then what is self GMD (Geometric Mean Distance) of the conductor?  (A) 2.645 R (B) 2.177 R (C) 2.141 R (D) 1.21 R

When ‘n’ resistances each of value ‘r’ are connected in parallel, then the resultant resistance is ‘x’. When these ‘n’ resistances are connected in series, total resistance is  (A) n2X (B) X/n (C) n2/X (D) nX2

A compact microstrip antenna may be obtained by

what are different three main IC Technologies? discuss the advantages of each of them.

Starting torque can be obtained in the case of a single phase induction motor with identical main and auxiliary windings by connecting:  (1) A capacitor across the mains (2) A capacitor in series with the machine (3) A capacitor is series with the auxiliary winding (4) Equal value capacitors in series with the main and the auxiliary windings

If three amplifiers having the same bandwidth are cascaded, the bandwidth of the resulting amplifier will be (a) Better than that of each stage (b) Worse than that of each stage (c) Same as that of each stage (d) None of the above

How many bits Internet address is assigned to each host on a TCP/IP Internet which is used in all communications with host?  A) 16 bits B) 32 bits C) 48 bits D) 64 bits

When three resistors with unequal values are connected in parallel, _______ A) The current across the resistors is the same  B) The voltage drop across the resistors is the same C) The voltage drops across the resistors is proportional to the resistance of each resistor D) None of these

A three phase transmission line delivers a load of 5 MW at 0.8 power factor lagging. Resistance of each conductor is 0.5 ohm / km. Receiving end voltage is 33 kV. If the line loss is not to exceed 10%, determine the length of the line.  (A) 7 km (B) 27.9 km (C) 56.8 km (D) 13.9 km

Three phase synchronous motor will have how many sliprings?

A binary ladder with R -2R network has R = 20K Ohms. The total resistance looking out toward the LSB input is (a) 20KOhms (b) 40KOhms (c) 10KOhms (d) 30KOhms

A dc shunt motor runs at 500 r.p.m at 220 V. A resistance of 4.5 Ω is added in series with the armature for speed control. The armature resistance is 0.5 ohms. The current to stall the motor will be (1) 44 A (2) 50 A (3) 44.4 A (4) 60 A

A high-pass filter has a resistance R = 2 kΩ The lowest input frequency to be passed is 7.5 kHz. The value of suitable coupling capacitor must be: A) 0.001 pico Farad B) 0.01 pico Farad C) 0.1 pico Farad D) 1 pico Farad

What should be kVA rating of each transformer in V-V bank when three phase balanced load is 40 kVA ? (A) 19 (B) 28 (C) 37 (D) 23

How many characters per sec (7 bits + 1 parity) can be transmitted over a 2400 bps line if the transfer is synchronous (1 start bit and 1 stop bit)?  A) 300 B) 240 C) 250 D) 275

For a short transmission line with r/x ratio of is 1.0, the regulation will be zero when the load power factor is

A 35 V dc supply is connected across a resistance of 600 ohm in series with an unknown resistance R. A voltmeter having a resistance of 1.2 kOhm is connected across 600 ohm resistances and reads 5 V. The value of resistance R shall be:

A moving coli ammeter has a fixed shunt of 0.02 Ω with a coil circuit resistance of R=1 kΩ and needs potential of 0.5 V across it for full scale deflection. Calculate the value of shunt to give full scale deflection when the total current is 10 A. (1) 0.05 Ω (2) 0.005 Ω (3) 0.5 Ω (4) 0.0005 Ω

A parallel combination of capacitance C and resistance R is connected in series with inductance L and small resistance r. Under what condition will the circuit be non-reactive?  (A) C=LR (B) C=LR2 (C) C=L/R2 (D) C=L/R

If resistance is 20 Q. and inductance is 27 in a R-L series circuit, then time constant of this circuit will be?

Five cells, each with an e.m.f. of 2V and internal resistance of 0.5Ω are connected in series. The resulting battery will have

A two-phase generator is connected to two 90Ω load resistors. Each coil generates 120 V ac. The value of current flowing through the common neutral line will be: A. 1.33 A B. 1.88 A C. 2.66 A D. 1.77 A

With three resistances connected in parallel, if each dissipates 20 W the total power supplied by the voltage source equals?

Approximately how many milliamperes of current flow through a circuit with a 40 V source and 6.8 k ohms of resistance? A.27.2 mA B.59 mA C.5.9 mA D.590 mA

The kVA rating of Three-phase transformer with Voltage = 200V and Current = 100A will be :  (A) 34.64 kVA (B) 75 kVA (C) 20 kVA (D) None of the above

How many servos can be controlled by Arduino?

For optimum generator scheduling for different power plants, the minimum fuel cost is obtained when

Three identical resistors connected in star consume 5000 W. If the resistors are connected in delta across the same supply, the power consumed will be

Three resistors of 4 Ω, 6 Ω and 9 Ω are connected in parallel. Which resistor consumes the maximum power?  (A) 4 Ω (B) 6 Ω (C) 9 Ω (D) 17 Ω

A star circuit has element of resistance R/2. The equivalent delta elements will be?

The equation of 50 Hz current sine wave having r.m.s. value of 60 A is?

Three different points are shown on a dc load line. The upper point represents the : -  a) minimum current gain b) quiescent point c) saturation point d) cutoff point

what are the three different types of Electric power?

Three single phase transformers each with 10 kVA rating are connected in a closed delta arrangement. If one transformer is taken out, the output capacity of the system will be (a) 20 kVA (b) 8.66 kVA (c) 17.32 kVA (d) 10 kVA