# Two aluminium conductors have equal length. The cross-sectional area ...

15 views
Two aluminium conductors have equal length. The cross-sectional area of one conductor is four times that of the other. If the conductor having smaller cross-sectional area has a resistance of 100 ohms the resistance of other conductor will be

Two aluminium conductors have equal length. The cross-sectional area of one conductor is four times that of the other. If the conductor having smaller cross-sectional area has a resistance of 100 ohms the resistance of other conductor will be 25 ohms.

## Related questions

Two copper conductors have equal length. The cross-sectional area of one conductor is four times that of the other. If the conductor having smaller cross-sectional area has a resistance of 40 ohms the resistance of other conductor will be?

What happens to the resistance of a wire when its length as well as the cross-sectional area are doubled? A) It doubles B) It becomes 4 times C) It becomes 2π times D) It remains the same

A galvanised steel tower member has original length of 22cm and cross sectional area of 13 cm2. With working axial tensile load of 125 KN, the change in length was 0.2 mm. Calculate the percentage of elongation.  (A) 0.0712% (B) 0.00612% (C) 0.0909% (D) 0.19%

The primary turns of a 444 V/222 V, 50 Hz single-phase transformer with a core cross-sectional area of 100 cm2, and a maximum flux density of 1.0 T is (A) 100 (B) 200 (C) 222 (D) 400

If the cross-sectional area of a magnetic field increases, but the flux remains the same, the flux density: A. increases B. decreases C. remains the same D. doubles

With the increase in the cross sectional area of the conductor, the value of resistance:  (1) Increase (2) Remain same (3) Decrease (4) None of these

Two heater wires of equal length are connected first in series and then in parallel. The ratio of heat generated from series to parallel connection will be (a) 4 : 1 (b) 2 : 1 (c) 1 : 2 (d) 1 : 4

In order to reduce cross sectional dimension, the wave guide to use is

Voltages phasors at the two terminals of a transmission line of length 70 km have a magnitude of 1.0 per unit but are 180 degree out of phase. Assuming that the maximum load current in the line is 1/5th of minimum 3-phase fault current. Which one of the following transmission line protection schemes ... pick up at 1.25 times the maximum load current (C) Pilot relaying system with directional comparison scheme (D) Pilot relaying system with segregated phase comparison scheme

lt the length, number of turns and area of a coil are  doubled, the inductance of the coil

For a transient stability analysis, as long as equal area criterion is satisfied, the maximum angle to which rotor angle can oscillate is:  (A) 0˚ to 20˚ (B) 45˚ to 50˚ (C) Greater than 90˚ (D) 65˚ to 85˚

Two transformers are connected in parallel. These transformers do not have equal percentage impedance. This is likely to result in?

The 'Equal area criterion' for the determination of transient stability of a synchronous machine connected to an infinite bus  (1) ignores line as well as synchronous machine resistance and shunt capacitances.  (2) assumes accelerating power acting on the rotor as constant.  (3) ignores the effect of voltage ... inherent damping present in the machine.  (4) takes into consideration the possibility of machine losing synchronism after it has survived during the first swing.

Equal area criterion gives the information regarding  (1) stability region (2) absolute stability (3) relative stability (4) swing curves

Two parallel conductors are separated by a distance, d carrying a current, I in the same direction. The magnetic field along a line running parallel to the conductors and midway between them is (A) zero (B) proportional to I (C) proportional to d (D) proportional to the permeability of the medium.

What will be the phase angle between two alternating waves of equal frequency, when one wave attains maximum value the other is at zero value ?

The conductors have transport phenomena of electrons due to

for Delta-Star connection of 3-phase transformer: i) Draw the connection diagram ii) List any two advantages of this connection iii) State its area of application.

Two waves of the same frequency have opposite phase when the phase angle between them is?

Two transformers A and B having equal outputs and voltage ratios but unequal percentage impedances of 4 and 2 are operating in parallel. The transformer A will be overloaded by

In a two -channel oscilloscope operating in x -y mode, two in -phase 50 Hz sinusoidal waveforms of equal amplitude are fed to the two channels. What will be the resultant pattern on the screen ? (a) An ellipse (b) A parabola (c) Straight line inclined at 45° with respect to x-axis (d) A circle

A trolley wire weighs 1.2 kg per meter length. The ends of the wire are attached to two poles 20 meters apart. If the horizontal tension is 1500 kg find the dip in the middle of the span?

A 36 slot, 4 -pole, dc machine has a simplex lap winding with two conductors per slot. The back pitch and front pitch adopted could be respectively

Two long parallel conductors carry 100 A. If the conductors are separated by 20 mm, the force per meter of length of each conductor will be

Which have more free electrons: conductors or insulators?

For equilateral spacing of conductors of an untrasposed 3-phase line, we have?

All good conductors have high?

Two materials have resistance temperature coefficients of 0.004 and 0.0002 respectively at a given temperature. In what ratio should the wires made of these materials be connected in series so as to have an overall temperature coefficient of 0.002?

Two coils connected in series have resistance of 600 ohm and 300 ohm and temperature coefficients of 0.1% and 0.4% respectively.The resistance of the combination at 50oC will be

Two similar coils have self inductance of 1 mH each. Coefficient of coupling is 0.5. The mutual inductance M is

Which of the two generalized constants of a transmission line are equal?  (a) B & C (B) A & B (c) A & D (D) B & D

The resolved part of the resultant of two forces inclined at an angle 9 in a given direction is equal to

Name two good conductors, two good insulators, and two semiconductors.

Aluminium conductor cables can be joined by   (a) Gas welding (b) Soldering (c) Compression (d) Thermit welding

In a 4-pole wave winding connected dc motor, the cross-magnetizing AT/pole for a brush shift of θ radians (A) Armature amp-conductors × (θ/360o) (B) Armature amp-turns × (θ/360o) (C) Armature amp-conductors × (1/4 - θ/360o) (D) Armature amp-conductors × (1/8 - θ/360o)

What happens to the reluctance of a magnetic circuit, when an air gap is introduced to the core cross section ? (A) Decreases (B) Increases (C) Remain same (D) None of the above

Comparing the total copper cross sections in terms of current-carrying capacity for a single-phase and a three-phase 120 V system with effective load resistance of 15Ω, will yield: A. single-phase 32 A; three-phase 16 A B. single-phase 16 A; three-phase 8 A C. single-phase 8 A; three-phase 4 A D. single-phase 16 A; three-phase 0 A

The resistance of a strip of copper of rectangular cross-section is 2Ω. A metal of resistivity twice that of copper is coated on its upper surface to a thickness equal to that of copper strip. The resistance of composite strip will be