14 views
in Electrical Engineering by

Your answer

Thanks for your contribution. Feel free to answer this question. Please avoid short answer. Your answer is most welcome. Be genuine.

Upload image or document:

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
Are you a robot ? (Y = Yes / N = No)
To avoid this verification in future, please log in or register.

1 Answer

0 votes
by

The value of the capacitor in a capacitor start motor controls the starting torque

Related questions

1 answer 15 views

Reduction in the value of capacitance of a capacitor -start motor, results in reduced: (A) noise (B) speed (C) starting torque (D) armature reaction

asked Apr 11, 2018 in Computer Engineering by Shimroz123
1 answer 21 views

In a capacitor start single-phase induction motor, the capacitor is connected in:  (A) series with the main winding (B) series with the auxiliary winding (C) series with both the windings (D) parallel with the auxiliary winding .

asked Apr 9, 2018 in Electrical Engineering by Shimroz123
1 answer 14 views

In the capacitor-start, capacitor-run single-phase induction motor (A) two capacitors are connected across the main winding (B) when the centrifugal switch opens, the permanent capacitor is left in the auxiliary winding circuit (C) when the centrifugal switch opens, the permanent capacitor is left in the main winding circuit (D) two capacitors are connected across the auxiliary winding.

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 13 views

For a single phase capacitor start induction motor, which of the following statements is valid?  A) The capacitor is used for power factor improvement B) The direction of rotation can be changed by reversing the main winding terminals C) The direction of rotation cannot be changed D) The direction of rotation can be changed by interchanging the supply terminals

asked May 17, 2018 in Induction Machine by Shimroz123
1 answer 11 views

A capacitor start, capacitor run single phase induction motor is basically a : -  a) ac series motor b) dc series motor c) 2 phase induction motor d) 3 phase induction motor

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
0 answers 83 views

number of windings of a coil in a stator of ac motor for ey slot ac motor

asked Aug 29, 2018 in Electrical machine design by normzhie
1 answer 14 views

 As compared to a split phase motor, a capacitor start motor has _____.

asked May 29, 2018 in Electrical Machine by Shimroz123
1 answer 25 views

A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will?

asked Mar 20, 2018 in Induction Machine by Shimroz123
1 answer 26 views

If the output filter capacitor in a power supply actually had a value twice its stated value, which of the following symptoms would be found?   a. The output voltage would be doubled and a small improvement in the ripple voltage would be detected.  b. The ripple voltage would be half of what is expected and a ... output voltage would be detected.  c. The output and ripple voltage would be greater than expected.  d. The output and ripple voltage would be less than expected.

asked May 17, 2018 in Capacitor by Shimroz123
0 answers 17 views

Compare resistance split phase induction motor with capacitor start induction motor.

asked Sep 1, 2018 by Quiz
0 answers 23 views

Draw and explain capacitor start capacitor run single phase induction motor.

asked Sep 1, 2018 by Quiz
0 answers 24 views

Which type of starter is used to start the DC motor?

asked Mar 15, 2018 in Electrical Engineering by Quiz
0 answers 27 views

For a stepper motor which of the following torque has the highest numerical value ? (A) Detent torque (B) Pull -in torque (C) Pullout torque (D) Holding torque

asked Apr 14, 2018 in Electrical Engineering by Shimroz123
0 answers 22 views

The usual value of slip of a 3Φ induction motor at full load is about:  (A) 0.05 (B) 0.1 (C) 0.3 (D) 0.8 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 9 views

The synchronous motor can be used as a capacitor • By increasing excitation • By decreasing excitation • By increasing speed • By decreasing speed

asked May 13, 2018 in Electrical Engineering by Shimroz123
0 answers 24 views

What is a drive in electrical controls?

asked Mar 10, 2018 in Control of electric drives by Quiz
1 answer 8 views

Why shouldn’t a DC shunt motor start on the heavy load setting?

asked Jul 5 in DC motor by Shimroz123
0 answers 7 views

If the voltage applied across a capacitor is triangular in waveform, the waveform of the current is (a) Triangular (b) Rectangular (c) Sinusoidal (d) Trapezoidal

asked May 25, 2018 in Electrical Engineering by Shimroz123
1 answer 14 views

The purpose of connecting a capacitor in fluorescent tube circuit is • To increase switching on time • To decrease switching off time • To increase power factor • To decrease power consumption

asked May 14, 2018 in Electrical Engineering by Shimroz123
1 answer 15 views

An inductor of Q factor 10 is connected in series with a capacitor having a Q factor of 100. The overall Q factor of the circuit is :  (A) 100/11 (B) 11/100 (C) 110 (D) 1000

asked Apr 30, 2018 in Electrical Engineering by Shimroz123
1 answer 21 views

The purpose of a coupling capacitor in an amplifier is to:  (1) Control the output (2) Provide impedance matching (3) Provide DC isolation between amplifier and load (4) W Increase the bandwidth

asked Apr 9, 2018 in Electrical Engineering by Shimroz123
1 answer 41 views

In an induction motor if the flux density is reduced to one-half, of its normal value then the torque will  (1) reduce to one-half (2) reduce to one-fourth (3) remain unchanged (4) increase four times

asked May 1, 2018 in Electrical Machine by Shimroz123
1 answer 39 views

What is the maximum value of torque angle in synchronous motor?

asked Mar 18, 2018 in Synchronous machine by Shimroz123
0 answers 10 views

For the given voltage and current, the value of voltage regulation of a line for lagging loads with decrease in power factor (a) decreases (b) increases (c) remains same (d) either (a) or (c) 

asked May 25, 2018 in Electrical Engineering by Shimroz123
1 answer 14 views

At temperatures above a limiting value, the energy of lattice vibrations, in a conductor, increases linearly with temperature so that resistivity increases linearly with temperature. In this region, this limiting value of temperature is called

asked Apr 23, 2018 in Electrical Engineering by Shimroz123
1 answer 8 views

In a superconductor, if the temperature is decreased below its critical temperature, the value of critical magnetic field will (a) Increase (b) Decrease (c) Not change (d) Increase or decrease depending on the superconductor material

asked Apr 23, 2018 in Electrical Engineering by Shimroz123
0 answers 11 views

In a series RLC circuit at resonance, which of the following quantities attains maximum value ? (A) Current (B) Voltage (C) Power (D) None of the above

asked Apr 14, 2018 in Electrical Engineering by Shimroz123
0 answers 22 views

In a series RLC circuit, the rms value of voltage across the resistor is 30 V, across the inductor is 60 V and across the capacitor is 20 V. The rms supply voltage would be (A) 110 V (B) 10 V (C) 220 V (D) 50 V

asked Apr 14, 2018 in Electrical Engineering by Shimroz123
1 answer 13 views

In a three-phase system, when the loads are perfectly balanced, the value of neutral current is equal to: A. Zero B. One-third of the maximum value C. Two -third of the maximum value D. The maximum value

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
1 answer 29 views

If eight -tenths coulomb passes a point in 4 s, the value of current is equal to: A. 1.6 A B. 16 A C. 2 A D. 0.2 A

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
1 answer 40 views

The normal value of the armature resistance of a d.c. motor is?

asked Mar 26, 2018 in DC motor by Shimroz123
1 answer 73 views

D.C. motor is to drive a load which has certain minimum value for most of the time and some peak value for short duration. We will select the?

asked Mar 20, 2018 in DC motor by Shimroz123
1 answer 21 views

A coil of inductance 240 mH and resistance 75 Ohm is connected in parallel with a capacitor across a 30 V, variable frequency supply. The current drawn by the circuit is found to be minimum when the supply frequency is 1 kHz. The approximate values of Q-factor and bandwidth are, respectively (A) 40, 400 Hz (B) 10, 100 Hz (C) 20, 50 Hz (D) 50, 20 Hz

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 13 views

When an alternating potential is applied to a capacitor, the current in the circuit will  1. lead the applied potential 2. lag the applied potential 3. be in phase with the applied potential 4. none 

asked May 13, 2018 in Electrical Engineering by Shimroz123
1 answer 49 views

In an AC. circuit, a low value of kVAR compared with kW indicates?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 75 views

What is the value of susceptibility in case of vacuum? A) 1 B) 0.5 C) ∞ D) 0 

asked Jun 18, 2018 in Electrical Engineering by Shimroz123
0 answers 22 views

In an amplitude modulated wave. the value of V is max 10V and Vmin is 5V, then % modulation is : (A) 25% (B) 33.3% (C) 50% (D) 100%

asked Apr 14, 2018 in Electrical Engineering by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,538 questions

7,137 answers

135 comments

3,090 users

...