# What is peak factor of a sinusoidal wave?

14 views
What is peak factor of a sinusoidal wave?

(A) 1.11 (B) 1.414 (C) 3.142 (D) 4.44

## Related questions

What is crest factor (peak factor)? A) It is the ratio of the maximum amplitude to average value B) It is the ratio of the average amplitude and RMS value C) It is the ratio of the maximum amplitude to RMS value D) None of these

. If the peak transmitted power in a radar system is increased by a factor of 16, the maximum range will be increased by a factor of : (A) 2 (B) 4 (C) 8 (D) 16

For a sine wave with peak value Imax the r.m.s. value is?

The following formula is correct:  (A) Load factor=Average load for a period/ Peak load for the same period  (B) Load factor=Average load for a period x Peak load for the same period  (C) Load factor=Average load for a period + Peak load for the same period  (D) All of the above

An AC supply of 230 V is applied to half wave rectifier circuit. A transformer turns ratio is 20 : 1. Find i) Output DC voltage (ii) Peak Inverse Voltage (PIV)

The average value of a 12 V peak sine wave over one complete cycle is? A.0 V B.1.27 V C.7.64 V D.6.37 V

If the peak value of a sine wave is 30 V, the rms value is? A.19.08 V B.7.07 V C.0.707 V D.23.10 V

Output of an op-amp is a square wave of 4 V peak to peak with a rise time of 5 microsecond and fall time of 4 microsecond.Maximum frequency (in kHz)of undistorted sine wave output of 2 V peak to peak is about  A) 100 B) 150 C) 200 D) 250

When a sinusoidal voltage wave drives a Schmitt Trigger, the output is a:  A) Triangular wave B) Rectified sine wave C) Rectangular wave D) Trapezoidal wave

In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is: (1) 30 V (2) 60 V (3) 15 V (4) 10 V

An ac voltmeter using full -wave rectification and having a sinusoidal input has an ac sensitivity equal to  (1) 1.414 times dc sensitivity (2) dc sensitivity (3) 0.9 times dc sensitivity (4) 0.707 times dc sensitivity

Form factor for a sine wave is?

A peak reading voltmeter has been calibrated with a sine wave signal and scaled in rms volts. If a square wave signal ± 1V peak is applied, the meter reading will be (a) 0.555 V (b) 0.707 V (c) 1 V (d) 1.75 V

What is the average value of a perfect sine wave over a complete cycle ? (A) Zero (B) Peak value (C) rms value (D) None of the above

The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of______degrees.

An SSB transmitter produces a peak-to-peak voltage of 200 V across a 100 Ω antenna load. What is the Peak Envelope Power? A) 49.98 W B) 79.98 W C) 99.96 W D) 199.93 W

Two wattmeters are used to measure the power in a 3 -phase balanced system. What is the power factor of the load when one wattmeter reads twice the other ?  (a) 0 (b) 0.5 (c) 0.866 (d) 1

A 200 MW generator is having a plant capacity factor of 30% and a plant load factor of 50%. What will be the reserve capacity of the plant ? (A) 40 MW (B) 50 MW (C) 60 MW (D) 80 MW

What is the maximum data rate that can be transmitted using a QPSK modulation with a roll-off factor of 0.2 for a 36 MHZ transponder?  A) 7.2 Mbps B) 30 Mbps C) 43.2 Mbps D) 60 Mbps

What is the power factor of a cable of loss angle “ө”?  (A) sin ө (B) cos ө (C) tan ө (D) Independent of ө

What is the pitch factor of a 4 pole alternator having 36 slots and a coil span of 1 to 8?  (A) 140° (B) 80° (C) 20° (D) 40°

Ripple factor for a half wave rectifier is  a. 1.65 b. 1.45 c. 1 d. 1.21

A single core cable is designed to work for a single phase system with a peak voltage of 220 kV. The maximum permissible stress in the dielectric is not to exceed 20 kV/mm. For economical size, the overall core diameter of the cable is (A) 28.2 mm (B) 26.4 mm (C) 24.4 mm (D) 22.0 mm

The transformer utilization factor of full wave bridge rectifier is   (A) 0.812 (B) 0.286 (C) 0.693 (D) 0.782

In a two -channel oscilloscope operating in x -y mode, two in -phase 50 Hz sinusoidal waveforms of equal amplitude are fed to the two channels. What will be the resultant pattern on the screen ? (a) An ellipse (b) A parabola (c) Straight line inclined at 45° with respect to x-axis (d) A circle

What is the power factor when a single phase watt meter operating on 200 V and 5 A for 5 hours makes 2016 revolutions and the meter constant in revolution is 420? A) 0.04 B) 1.04 C) 0.96 D) None of these

Define form factor and peak factor.

What is the value of form factor in connection with single phase alternating supply systems ? (A) 1.01 (B) 1.11 (C) 1.21 (0) 1.31

What is the power factor of purely resistive circuit.

If the rms voltage drop across a 15 kilt resistor is 16 V, the peak current through the resistor is : -  a) 15 mA b) 1.5 mA c) 10 mA d) 1 mA

The direction of rotation of a 3-phase induction motor is clockwise when it is supplied with 3-phase sinusoidal voltage having phase sequence A-B-C. For counter clockwise rotation of the motor, the phase sequence of the power supply should be  (A) B-C-A (B) C-A-B (C) A-C-B (D) B-C-A or C-A-B

what is mean by sine wave?

Which of the following plants is suitable for peak load?  (A) Diesel engine plant (B) Steam power plant (C) Nuclear power plant (D) Hydro-electric plant

If Voltage Standing Wave Ratio, (VSWR) of a wave is 2, its reflection coefficient will be _____.

The r.m.s. value of a half-wave rectified alternating current is 10 A. Its value for full-wave rectification will be

A travelling wave of surge resistance, Ro on a transmission line is terminated by a load resistance, RL. If RL > Ro then there is (A) no reflected wave (B) partial reflection of reversal of current only (C) partial reflection of reversal of voltage only (D) reflection of reversal of both current and voltage

When the wave travels in a conducting medium, the rate of attenuation is decided by

A square wave has a period of 60 s. The first odd harmonic is: A. 5 kHz B. 50 kHz C. 500 kHz D. 33.33 kHz

The number of parallel paths in the armature winding of a 4 -pole, wave connected d.c. machine having 28 coilside is : -  a) 28 b) 14 c) 4 d) 2

In a Traveling-wave Tube, the velocity of electron beam with respect to the axial velocity of RF field is kept...  A) Lower B) Higher C) Equal D) Any of these