# If Ф = angle(G(jw)H(jw)) where w is the gain crossover frequency of Bode plot of the system, phase margin is ...

52 views
If Ф = angle(G(jw)H(jw)) where w is the gain crossover frequency of Bode plot of the system, phase margin is

A) -180+ Ф B) 180- Ф C) 180+ Ф D) -180- Ф

## Related questions

In the Bode plot of a unity feedback control system, the value of phase of G(jw) at the gain cross -over frequency is - 125°.. The phase margin of the system is (a) - 125° (b) - 55° (c) 55° (d) 125°

The loop transfer of a system is G(s) H(s) = 5/(s+1) (2s+1)(3s+1) which has the phase crossover frequency fc = 0.16 Hz. The gain margin (dB) of the system is  (a) 6 (b) 4 (c) 2 (d) 0

A unity negative feedback control system is found to have a gain margin of 20 dB. The Nyquist plot of the system (A) crosses the real axis at +0.1 (B) crosses the real axis at -0.1. (C) crosses the imaginary axis at -0.1 (D) crosses the imaginary axis at +0.1

Phase margin is the amount of angle to make the system  (1) Oscillatory (2) Stable (3) Unstable (4) Exponential

What will happen to the gain margin if the gain of the open loop system is doubled? A) Doubled B) Becomes half C) Is not affected D) Becomes one-fourth

If the gain of the open loop system is doubled, the gain margin  (1) Is not affected (2) Gets doubled (3) Becomes half (4) Becomes one -forth

What is the Bode amplitude plot of a first-order lowpass system?  (A) Line with slope -40 dB/decade (B) Line with slope -20 dB/decade (C) Line with slope +20 dB/decade (D) Straight line parallel to the frequency axis

A system with gain margin close to unity or a phase margin close to zero is (a) conditionally stable (b) relatively stable (c) highly stable (d) highly oscillatory

The gain margin of a system is 0 dB. It represents a   (a) Stable system (b) Unstable system (c) Marginally stable system (d) Conditionally stable system

The dc gain of the system represented by the transfer function G(s)=(s+6)/((s+2)(s+3)) is  A) 1 B) 2 C) 5 D) 6

For better relative stability, the values of gain margin and phase margin should be respectively  A) 6 db, 15 degree B) 10 db, 15 degree C) 10 db, 30 degree D) 6 db, 30 degree

If you used 600 W of power for 60 h, you have used? A.36 kWh B.3.6 kWh C.10 kWh D.1 kWh

The unit circle of the Nyquist plot transforms into unity or 0 dB line of the amplitude plot of the Bode diagram for

In a Bode magnitude plot, which one of the following slopes would be exhibited at high frequencies by a 4th order all-pole system? (A) – 80 dB/decade (B) – 40 dB/decade (C) +40 dB/decade (D) +80 dB/decade

The unity circle of Nyquist plot corresponds to zero dB line of Bode plot for  A) High frequencies B) Low frequencies C) Medium frequencies D) All frequencies

The Bode plot is used to analyze  A) All phase network B) Minimum phase network C) Non minimum phase network D) All networks

For a stable feedback control system, the phase margin is  a) always positive b) always negative c) may be positive or negative d) always greater than 180o

The step angle of the stepper motor is 2.5°. If the stepping frequency is 3600 pulses per second, then the shaft speed will be   (a) 144 rps (b) 3600 rps (c) 25 rps (d) 2.5 rps

Two waves of the same frequency have opposite phase when the phase angle between them is?

If the phase -angle of the voltage coil of a directional relay is 50°, the maximum torque angle of the relay is: (A) 130° (B) 100° (C) 50° (D) 25°

A system is critically damped. If the gain of the system is increased, the system will behave as: A) overdamped B) underdamped C) oscillatory D) critically damped

If the gain of the critical damped system is increased it will behave as?

What will be the phase angle between two alternating waves of equal frequency, when one wave attains maximum value the other is at zero value ?

Introduction to Bode Plot Introduction to Bode Plot

If the supply frequency of a 3-phase induction motor is ‘f’, then frequency of rotor emf at motor slip ‘s’ will be   (a) sf (b) (1 – s)f (c) f/s (d) None of these

Given a unity feedback system with G(s)=k/s (s+4), the value of k for damping ratio of 0.5 is

A single-phase ac voltage source has 200 V rms and a system connected consumes an active power of 300 W. What is the reactive power consumed by the system if 2.5 A rms current is drawn ?  (a) 100 VAR (b) 200 VAR (c) 300 VAR (d) 400 VAR

The phase angle corresponding to λ/4 in a standing– wave pattern is: (1) 30° (2) 90° (3) 135° (4) 180°

In the common–emitter transistor circuit, if the current gain is 100 and the collector current is 10 mA, the base current is: (1) 10 µA (2) 100 µA (3) 1 A (4) 10 A

In CRO, Lissajous pattern will be a straight line, if the two signals are of same frequency with a phase difference of (a) 0° (b) 180° (c) 360° (d) All of these

The eddy current loss in a dc generator is 400 W at 40 Hz frequency of reversal and constant flux density. When frequency is increased to 50 Hz., eddy current loss is :  (A) 256 W (B) 320 W (C) 500 W (D) 625 W

If the antenna diameter in a radar system is increased by a factor of 4, the maximum range will be increased by a factor of  (a) 2 (b) 4 (c) 8 (d) 16

If the inertia constant H of a machine of 200 MVA is 2 p.u., its value corresponding to 400 MVA will be   (a) 4 p.u. (b) 2 p.u. (c) 1.0 p.u. (d) 0.5 p.u.

By adding a pole at the origin of s -plane, the Nyquist plot of a system will rotate by (a) 90° in anti -clockwise direction (b) 90° in clockwise direction (c) 180° in anti -clockwise direction (d) 180° in clockwise direction

If frequency is decreased 4 times, then skin depth of an Electromagnetic wave inside a conductor will be :  A) halved B) quadrupled C) doubled D) no change

The critical point lies within the nyquist plot then the system is   (a) Marginally stable (b) Unstable (c) Stable (d) Undetermined

Which of the following is used extensively where lowest power consumption is necessary?  (1) CMOS (2) NMOS (3) PMOS (4) Any of the above

In root locus plot, a point on the real axis lies on the locus, if the number of open loop poles plus zeros on real axis to the a) left of the point is odd b) left of the point is even . c) right of the pointis odd d) right of the point is even

A series RLC circuit has a resonant frequency of 1 KHz and a quality factor Q = 100. If each of the R,L and C is doubled from its original value, the new Q of the circuit is:  (1) 25 (2) 50 (3) 100 (4) 200

In a three phase half wave rectifier feeding resistive load, if the input source is a three phase 4 wire system and line to line voltage is 100 V. The supply frequency is 400 Hz. The ripple frequency at the output is: (1) 400 Hz (2) 800 Hz (3) 1200 Hz (4) None of these

How many watt-hours represent 65 W used for 18 h? A.11.7 Wh B.1,170 Wh C.11,700 Wh D.117,000 Wh