Ask a Question
On chip oscillator of 8051 has a nominal frequency (in MHz) of...
On chip oscillator of 8051 has a nominal frequency (in MHz) of
A) 2 B) 8 C) 10 D) 12
to add a comment.
← Prev Question
Next Question →
to answer this question.
In a transistor Colpitts oscillator, C1 = 0.001 µF, C2 = 0.01 µF and L = 5 µH. The frequency of oscillation in
An OP amp has a slew rate of 1V/µs. At a signal frequency of 0.1 MHz, the maximum undistorted sine wave ...
A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz
The frequency stability of the oscillator output is maximum in _____.
The FM radio broad cast frequency band (in MHz) is...
Feedback factor at the frequency of oscillation of a Wien bridge oscillator is:
The effect of phase error of local oscillator on spectral components in coherent detection of SSB Amplitude...
When The dc converter in figure shown has a resistance load of R = 10 Ω and the input voltage is Vs 220 V the converter switch remains on, its voltage drop is Vo -2 V. The chopping frequency is fI K sW Vs If the duty cycle is 50%, determine: (a) the average output voltage V (b) the RMS output voltage Vo (c) the converter efficiency (d) the effective input resistance of the converter
An amplifier operating over the frequency range from 18 to 20 MHz has 10 kilo ohm input resistor. What is
Frequency stability of crystal oscillator is due to its...
In a radio transmitter, the frequency of the crystal oscillator will be stable for a long time if the quality factor
A 1000 V/400 V power transformer has a nominal short-circuit voltage Vsc = 40%....
For a transistor, Ceb=20pF, Ccb=5pF, re=1kOhm. Its figure of merit (in MHz) is about ...
The crystal oscillator frequency is very stable due to
In a digital voltmeter, the oscillator frequency is 400 kHz, the ramp voltage falls from 8V to 0V in 20 m sec.
A Lissajous pattern on an oscilloscope has 5 horizontal tangencies and 2 vertical tangencies. The frequency of...
For a resonant circuit with resonant frequency of 1 MHz a, 0 = 50 and R = 400, find the value of C
The Q factor of a coil at resonant frequency 1.5 MHz of an RLC series circuit is 150. The Bandwidth is : -
A series RLC circuit has a resonant frequency of 1 KHz and a quality factor Q = 100. If each of the R,L and C...
List two types of oscillator, which generates frequency in RF range.
The 8259 peripheral chip for 8055 microprocessor is a ...
In satellite communication, frequency modulation is used because satellite channel has...
A pulse compression radar transmits an encoded pulse having a frequency chirp from 990 MHz to 1010 MHz
The bit addressable RAM of 8051 are at byte location (in Hex) ...
Propagation medium of the signal in band (3 to 30) MHz is by ...
In a Hartley oscillator, L1 = 0.1 mH, L2 = 10 µH and mutual inductance between coils equals 20 µH. The
The clock frequency of an 8085 microprocessor based system is 3 MHz. What should be the minimum pulse
Assertion (A) : Wein bridge oscillator is generally used as a variable audio frequency oscillator Reason (R) :
An accelerometer has input range of 0 to 10g, natural frequency 30 Hz and mass 0.001 kg. The range of the
When a sine wave has a frequency of 100 Hz in 12 s it goes through?
A system has 14 poles and 2 zeros in its open -loop transfer function. The slope of its highest frequency ...
In the telephone, the dial tone has a frequency of
Television channel allocation (in MHz) for VHF band III is...
In CCIR PAL B Television standards, sound IF (in MHz) is at...
In medium-scale integration (MSI), a chip contains
Draw the labeled circuit of RC phase shift oscillator. State the formula for frequency of oscillator.
Which of the following is a negative-resistance microwave device for oscillator applications?
While calculating performance of medium transmission line, what assumptions are made in case of (i) Nominal 'T' Method (ii) Nominal 'TT' Method.
In a full wave rectifier with input frequency of 50 Hz, the frequency of the output is:
Each flip-flop in a 4-bit ripple counter introduces a maximum delay of 40 n sec. The maximum clock frequency
Positive feedback is used in 1. Amplifier 2. Rectifier 3.Oscillator 4. Detector
A 100 km transmission line is designed for a nominal voltage of 132 kV and consists of one
Which instruction of 8051 microcontroller is used for reading data from code memory?
8051 microcontroller is capable of accessing external memory of...
AM transmitter operating below about 5 MHz usually make use of...
In the case of a 70–MHz IF carrier for a transponder bandwidth of 36 MHz, energy must lie between MHz:
A microprocessor is a _______ chip integrating all the functions of a CPU of a computer.
A Hartley Oscillator is used for generating
In a 741 Op-Amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to the
In a PCM system of telemetry, the quantization noise depends on: