15 views
in Electronics Engineering by
An FET is a 

(a) bipolar semiconductor device (b) unipolar semiconductor device (c) non semiconductor device (d) both (a) and (c) 

Related questions

1 answer 43 views

An FET is a better chopper than a BJT because it has (A) lower offset voltage (B) higher series ON resistance (C) lower input current (D) higher input impedance

asked Apr 26, 2018 in Electronics Engineering by Shimroz123
1 answer 13 views
1 answer 12 views

Pinch off voltage of a J FET is the drain to source voltage above which drain current. • Increases • Decreases • Remains constant • Becomes zero

asked May 14, 2018 in Electronics Engineering by Shimroz123
1 answer 13 views
1 answer 21 views

A FET is preferred over an ordinary transistor because it  1. Permits high degree of isolation between input & output circuits 2. Has low noise level 3. Has very high power gain 4. Has all the above properties 

asked May 13, 2018 in Power Electronics by Shimroz123
0 answers 129 views

FET is advantageous in comparison with BJT because of  A) High input impedance B) High noise C) High gain bandwidth product D) Its current controlled behavior

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
1 answer 51 views

What are the advantages of FET?

asked Jan 5, 2018 in Electronics Engineering by Quiz
1 answer 15 views

The gain of an FET amplifier can be changed by changing: (1) rm (2) gm (3) Rd (4) None of these

asked May 28, 2018 in Amplifier by Shimroz123
1 answer 63 views

What is the difference between BJT and FET?

asked Mar 19, 2018 in Bipolar Junction Transistor by Zeeshan
1 answer 28 views

Is the input impedance of MOSFET more than BJT and FET?

asked Mar 19, 2018 in MOSFET by Shimroz123
1 answer 33 views

An SSB transmitter produces a peak-to-peak voltage of 200 V across a 100 Ω antenna load. What is the Peak Envelope Power? A) 49.98 W B) 79.98 W C) 99.96 W D) 199.93 W

asked Jun 18, 2018 in Electronics Engineering by Shimroz123
1 answer 37 views

 An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to secondary turn’s ratio 12:1. The peak inverse voltage is A) 8.62 V B) 12 V C) 19.17 V D) 27.11 V 

asked Jun 18, 2018 in Electronics Engineering by Shimroz123
1 answer 21 views

An FM signal with modulation index mƒ is passed through a frequency tripler. The modulation index of the output signal will be (1) mƒ (2) 3mƒ (3) 9mƒ (4) 27mƒ

asked May 28, 2018 in Electronics Engineering by Shimroz123
1 answer 18 views

In an R-2R ladder D/A converter, the input resistance is  1. Not same for all digital inputs 2. R for each input 3. 2R for each input 4. 3R for each input 

asked May 13, 2018 in Electronics Engineering by Shimroz123
1 answer 33 views

In a 3-phase converter circuit during commutation when one SCR in one phase is turned on to turn-off an SCR in another phase, results in (A) voltage notching (B) harmonic distortion (C) voltage sag (D) voltage swell

asked Apr 28, 2018 in Electronics Engineering by Shimroz123
1 answer 13 views

The effect of a finite gain of an operational amplifier used in an integrator is that (A) it would not integrate (B) the slope of the output will vary with time (C) the final value of the output voltage will reduce (D) there will be instability in the circuit

asked Apr 26, 2018 in Electronics Engineering by Shimroz123
1 answer 15 views

In a half-wave rectifier, if an a.c supply is 60 Hz. Then what is the a.c ripple at output? (A) 30 Hz (B) 60 Hz (C) 20 Hz (D) 15 Hz

asked Apr 26, 2018 in Electronics Engineering by Shimroz123
1 answer 24 views

A 339 IC is an example of a fourteen-pin DIP that can be made to function as a ________:  (1) Comparator (2) 555 timer (3) D to A converter (4) Ladder network

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
1 answer 56 views

What device is similar to an RTD but has a negative temperature coefficient?  A) Strain gauge B) Thermistor C) Negative-type RTD D) Thermocouple

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
0 answers 19 views

If frequency is decreased 4 times, then skin depth of an Electromagnetic wave inside a conductor will be :  A) halved B) quadrupled C) doubled D) no change

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
0 answers 9 views

An example of a non-vectored interrupt in 8085 microprocessor is  A) INTR B) TRAP C) RST 5.5 D) RST 7.5

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
0 answers 591 views

Schmitt trigger is an example of a  A) Mono-stable multivibrator B) Bistable multivibrator C) Astable multivibrator D) None of the above

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
0 answers 16 views

As compared to a closed loop system an open loop system is  (a) more stable as well as more accurate (b) less stable as well as less accurate (c) more stable but less accurate (d) less stable but more accurate

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
0 answers 29 views

For an ADC, full scale output voltage is about 10 V.For a resolution of about 9.78mV, number of bits required is  A) 6 B) 8 C) 10 D) 12

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
0 answers 14 views

Velocity of an electron (in km/S) starting at rest and travelling to a point 100 V above the starting potential is around  A) 3600 B) 4000 C) 5100 D) 6000

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
0 answers 39 views

An amplifier which has almost same gain and input resistance of a CE amplifier but of higher bandwidth is  A) Cascode amplifier B) Cascade amplifier C) Darligton amplfier D) CC amplifier

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
0 answers 16 views

Output of an op-amp is a square wave of 4 V peak to peak with a rise time of 5 microsecond and fall time of 4 microsecond.Maximum frequency (in kHz)of undistorted sine wave output of 2 V peak to peak is about  A) 100 B) 150 C) 200 D) 250

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
1 answer 7 views
1 answer 16 views
1 answer 12 views

A long wire carrying 100 amp is placed in an external magnetic field of 50 gauss. The wire is at right angles to the field.

asked Mar 28, 2018 in Electronics Engineering by Shimroz123
1 answer 10 views

Compare BJT with FET

asked Sep 5, 2018 by Shimroz123
1 answer 170 views

Compare between BJT and FET on the basis of (i) Biolar/Unipolar (ii) Tharmal Runaway (iii) Noise (iv) Applications

asked Sep 5, 2018 by Shimroz123
1 answer 8 views

Define pinch off voltage and drain resistance of FET.

asked Sep 5, 2018 by Shimroz123
1 answer 11 views

List different types of FET.

asked Sep 4, 2018 by Shimroz123
0 answers 31 views

FET belongs to which of the following type of device?  (A) Current controlled device (B) Magnetic device (C) Power controlled device (D) Voltage controlled device 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 27 views

The total power of an AM transmitter having a carrier power of 50 W and the percentage of modulation at 80% is A) 50 W B) 66 W C) 68 W D) 70 W 

asked Jun 18, 2018 in Electronics Engineering by Shimroz123
1 answer 10 views

For an earth station transmitter, with an antenna output power of 40dBW 10,000W, a back-off loss of 3dB, a total branching and feeder loss of 3dB, a total branching and feeder loss of 3dB and transmit antenna gain of 4dB, the effective isotropic radiated power (EIRP will be  a) 38dBW b) 40 dBW c 36 dBW d) 47 dBW

asked Jun 15, 2018 in Electronics Engineering by Shimroz123
1 answer 76 views

Norton’s theorem states that a complex network connected to a load can be replaced with an equivalent impedance (A) in series with a current source (B) in parallel with a voltage source (C) in series with a voltage source (D) in parallel with a current source

asked Apr 26, 2018 in Electronics Engineering by Shimroz123
0 answers 31 views

An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured 5 A The limiting error is  A) 2% B) 2.5% C) 4% D) 5%

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
0 answers 126 views

An electron having an energy of 20 eV enters a magnetic field of 0.02 webers/sqm at an angle of 30degrees to the field. The time of travel (in nS)of the electron for one revolution is about  A) 1.78 B) 4.21 C) 7.82 D) 10.24 

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
1 answer 17 views

The current in a circuit with resistance in 6 amp. When an additional resistance of 4 ohms is inserted the current drops to 4 amp. The original resistance in ohms is

asked Mar 28, 2018 in Electronics Engineering by Shimroz123
1 answer 24 views

 An energy signal has G(f) = 20. Its energy density spectrum is A) 20 B) 100 C) 400 D) 800  

asked Jun 18, 2018 in Electronics Engineering by Shimroz123
1 answer 14 views

 In thermo-couple instruments, in which of the following is an emf caused if the junction of two wires of dissimilar metals is heated and the free or cold ends are connected to a milli-voltmeter? A) Kelvin effect B) Hot wire effect C) Seebeck effect D) Faraday effect 

asked Jun 17, 2018 in Electronics Engineering by Shimroz123
1 answer 18 views

The following is not an application of varactor diode:  a) Parametric amplifier b) Frequency tuner c) Voltage controlled oscillator d) Phase shifter

asked Jun 15, 2018 in Electronics Engineering by Shimroz123
1 answer 17 views

The transient current in lossless L-C circuit when excited from an AC source is, sine wave  (a) Critically damped (b) Underdamped (c) Overdamped (d) Undamped

asked May 16, 2018 in Electronics Engineering by Shimroz123
1 answer 15 views

The time constant of an RC circuit is defined as the time taken by the voltage across the capacitor to become_____ of its final value   (a) 63.2% (b) 36.8% (c) 50% (d) 100%  

asked May 13, 2018 in Electronics Engineering by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,450 questions

7,047 answers

132 comments

3,084 users

...