Ask a Question
A derivative controller is mainly used for...
A derivative controller is mainly used for
A) Improving transient response B) Decreasing steady state error C) Making steady state error zero D) All the above
to add a comment.
← Prev Question
Next Question →
to answer this question.
For a system with derivative feedback, forward path transfer is G(s) = I / (s2 + s + 1) and feedback path
A PD controller is used to compensate a system. Compared to the uncompensated system, the compensated
In a PID controller,the values of proportional, integral and derivative are dependent on...
Compare Integral controller with derivative controller.
A mast antenna is used mainly for :
Which topology is used for a central Network controller
The transient response of a system is mainly due to?
If stability error for step input and speed of response be the criteria for design, what controller would you
The type of instruments used mainly for standardizing instruments in laboratories is
High Voltage DC (HVDC) transmission is mainly used for
In satellite communication, scrambling is mainly used for -
A plant is modeled as 1/(s(s+3)) with unity feedback control system and a cascade PI controller. ...
A controller, essentially, is a ?
In a control system the output of the controller is given to?
Waveguide are used mainly for microwave signals because
Thermocouples are mainly used for the measurement of?
Load flow study of a power system is mainly carried out for
Which is true? A) Page Class is a derivative of the Control class. B) Page Class inherits all properties, methods, ...
In the PID controller, which gain term only effects the transient response? Why?
Deep bar rotor construction is used in three phase induction motors to mainly:
Light triggering is mainly used in
The iron alloy, ALNICO is mainly used to make ________
The DFD is (1) modern version of flowchart (2) mainly used at system specification stage (3) primary output ...
The Central Electricity Regulatory Commission (CERC) is mainly responsible for:
The B-register in 8751 micro controller is used
Companding is a technique used to achieve: -
A differentiator is not usually used in control system, because it : -
Transfer function of a system is used to calculate ...
In a closed-loop system in which the output is the speed of a motor, the output rate control can be used to_________.
Bundled conductors are mainly used in high voltage overhead transmission lines to
Stranded wires are mainly used to
Silicon steel used in laminations mainly reduces?
The best method for determining the stability and transient response of a control system is
For a stable feedback control system, the phase margin is
For a feedback control system of type 2, the steady error for a rap input is
The characteristic equation for a closed loop system with forward gain K is s4 + 4s3 + 8s2 + 6s + K = 0.
For a 2nd order servo system, the damping ratio δ = 0.5456 and undamped natural frequency is
Given a unity feedback system with G(s)=k/s (s+4), the value of k for damping ratio of 0.5 is
Observability of a system is essential for
Define the term BUS related to microprocessor/controller and list different buses used in microcontroller.
State the working principle and operation of Automatic power factor controller used in Transmission and Distribution system.
The efficiency of a transformer is mainly dependent on:
The hum in a transformer is mainly attributed to?
Static error co-efficients are used as a measure of the effectiveness of...
The Bode plot is used to analyze...
In derivative error compensation the output
Explain how a Programmable Logic Controller (PLC) is different from an ordinary personal computer. Also write the advantages and disadvantages of PLC.
The Intel 8259 is a - chip programmable interrupt controller
A Unified Power Flow Controller (FACTS controller) is a voltage source converter based
The basic limitation of a P-action only controller is