# Fibre optics have maximum segment

7 views
Fibre optics have maximum segment

A) 500 m B) 200 m C) 100 m D) 2000 m

Fibre optics have maximum segment 2000 m

## Related questions

SC and ST fiber optics cable connectors represent  (1) Synchronous Channel & Synchronous Terminal (2) Subscriber Channel & Synchronous Terminal (3) Synchronous Channel and Straight Tip (4) Subscriber Channel and Straight Tip

What will be the output of following code segment: int i=-7; printf(“%d”,0<!i); (1) 0 (2) non zero value (3) error (4) unpredictable value

Two waves have frequency of 500 Hz. One is set at its maximum value whereas the other at zero. The phase angle between them will be

State principle of optical fibre.

Fibre glass insulation can be used up to temperature of (A) 60°C (B) 80°C (C) 130°C (D) 180°

Consider the following program segment with 8085 microprocessor  LXI H 3600H  MOV A, M  HLT  The MOV instruction involves (a) indirect addressing (b) immediate addressing (c) implicit addressing (d) direct addressing

The distance between two coil sides which are connected to the same commutator segment is called as  (1) winding pitch (2) back pitch (3) front pitch (4) full pitch

Modern computers are reliable but they don't have ____.  a) Fast b) Powerful c) Cheap d) Self thinking

A 3 phase, 400 volts, 50 Hz, 100 kW, 4 pole squirrel cage induction motor with a rated slip of 2% will have a rotor speed of: (A) 1500 rpm (B) 1470 rpm (C) 1530 rpm (D) 1570 rpm

In object oriented design of software, objects have  A) Attributes and name only B) Operations and name only C) Attributes name and operations D) None of these

Stack does not have one of the following methods  (1) Pop (2) push (3) Top (4) replace

The maximum power in a synchronous motor (for a given excitation) is produced when the power angle is equal to: (A) 0° (B) 45° (C) 60° (D) 90°

If the phase -angle of the voltage coil of a directional relay is 50°, the maximum torque angle of the relay is: (A) 130° (B) 100° (C) 50° (D) 25°

If the number of conditions in a decision table is n, the maximum number of rules (columns) possible is  A) n B) 2n C) 2n D) log2n

Which have more free electrons: conductors or insulators?

Why donor and receiver atoms can't move when sufficient voltage is supplied if they have charge Thanks

The ideal operational amplifier does not have: (1) Infinite input resistance (2) Infinite output resistance (3) Infinite voltage gain (4) Infinite bandwidth

Which alternator will have more number of poles ? (a) coupled to steam turbine (b) coupled to gas turbine (c) coupled to hydraulic turbine (d) None of the above

Moving coil instruments have which one of the following scales ? (a) Logarithmic scale (b) Uniform scale (c) Non-uniform scale (d) Squared scale

A high-Q tuned circuit in an amplifier permits to have high (a) selectivity (b) fidelity (c) sensitivity (d) frequency ranges

A current transformer must at all times have (a) a secondary load (b) short circuited secondary (c) either (a) or (b) (d) none of these

A single phase transformer is designed to operate from 50 Hz, 1100 V supply and to have an output voltage of 240 V at no load. The core has mean area of 30 cm2 and the flux density has not to exceed 1.3T. The number of secondary turns will be (a) 1270 (b) 1017 (c) 768 (d) 277

Voltages phasors at the two terminals of a transmission line of length 70 km have a magnitude of 1.0 per unit but are 180 degree out of phase. Assuming that the maximum load current in the line is 1/5th of minimum 3-phase fault current. Which one of the following transmission line protection schemes ... pick up at 1.25 times the maximum load current (C) Pilot relaying system with directional comparison scheme (D) Pilot relaying system with segregated phase comparison scheme

The materials used for permanent magnets should have

The magnetic field on the axis of a current carrying polygonal coil will have only a horizontal component parallel to the Plane of the coil

The following logic families have their propagation delay. Arrange them from lowest propagation delay to highest propagation delay. 1. TTL (Standard) 2. ECL 3. Low power CMOS 4. DTL (A) 2, 1, 4 and 3 (B) 2, 4, 1 and 3 (C) 4, 2, 3 and 1 (D) 1, 2, 3 and 4

Three phase step-up transformer installed at power house, just before commencement of transmission line, have:

The time/div and voltage/div axes of an oscilloscope have been erased. When a 1 kHz, 5V p-p square wave calibration pulse is connected to channel 1 ofthe scope the waveform observed on the screen is as shown in the upper trace of the figure. An unknown signal is connected to channel 2 (lower trace) ofthe scope. If the time/div and V/div on both channels are the same, the amplitude (pp) and period of the unknown signal are respectively.

With n nodes and b branches a network will have   (A) (b+n) links (B) b - n +1 links (C) b -n-1 links (D) b + n + 1 links

Modern capacitors which have high capacitance in small size use a dielectric of   (A) paper (B) rubber (C) ceramic (D) Mylar

The driving point impedance with poles at ω = 0(zero) and ω = ∞ (infinity) must have the  (a) s term in the denominator and an excess term in the numerator (b) s term in the numerator and an excess term in the denominator (c) s term in the numerator and equal number of terms in the numerator and denominator (d) s term in the denominator and equal number of terms in the numerator and denominator

If you used 600 W of power for 60 h, you have used? A.36 kWh B.3.6 kWh C.10 kWh D.1 kWh

Which of the following notations have two repetitions of zero ?  (P) 1’s complement with radix of number being 2  (Q) 7’s complement with radix of number being 8.  (R) 9’s complement with radix of number being 10.  (S) 10’s complement with radix of number being 10   Select the correct answer using the codes given below:   (a) P,Q and S (b) P and R (c) Q, R and S (d) P,Q and R

Distribution transformers have good all day efficiency due to  (A) low copper loss (B) low iron loss (C) low copper and iron loss (D) None of these

An accurate voltmeter must have an internal impedance of (A) very low value. (B) very high value (C) medium value. (D) zero Value

An absolutely integrable signal x(t) is known to have a pole at s = 2. Which one of the following is true ? (A) B, C and D are true (B) x(t) can be left-sided (C) x(t) can be right-sided (D) x(t) can be both-sided

For a discrete time filter to be causal and to have exact linear phase (A) Its impulse response must be of infinite length (B) Its impulse response can be of any length (C) The signal should be left sided (D) Its impulse response must be of finite length

A fuse wire should have :  (A) Low specific resistance and high melting point (B) Low specific resistance and low melting point (C) High specific resistance and high melting point (D) High specific resistance and low melting point

A 17 inch personal computer uses approximately 150 watts in an hour. If you have same computer on for only 4 minutes (for checking e-mail) what would be the power consumption?  (A) 0.1 kW (B) 0.04 kW (C) 0.01 kW (D) None of the above

A transmission line has 1 P.0 impedance on a base of 11 KV, 100 MVA. On a base of 55 KV. it will have a P.0 impedance of

A voltage source inverter will have better performance if its  (1) load inductance is small and source inductance is large.  (2) both load and source inductance are small.  (3) both load and source inductances are large.  (4) load inductance is large and source inductance is small.

In order to have a lower cost of electrical energy generation the load factor  (1) and the diversity factor should be low (2) should be low but the diversity factor should be high (3) should be high but the diversity factor should be low (4) and the diversity factor both should be high

Which of the following does not have a commutator? A) Dynamo B) Induction motor C) Universal motor D) None of these