# Conductance is measured in: A. Henries B. Mhos C. Hertz D. Watts

8 views
Conductance is measured in: A. Henries B. Mhos C. Hertz D. Watts

Conductance is measured in: Mhos

## Related questions

0 answers 7 views

Calculate the resistance value in ohms for the following conductance values: (a) 0.002 S (b) 0.004 S (c) 0.00833 S (d) 0.25 S.

0 answers 13 views

Calculate the resistance value in ohms for the following conductance values: (a) 0.001 S (b) 0.01 S (c) 0.1 S (d) 1 S.

0 answers 804 views

In river crossing, hilly terrain, modern HV lines have span more than (a) 50 m (c) 500 m (b) 100 m (d) 800 m

1 answer 14 views

Converting 7,000 nA into microampere will result in: A. 0.007 µA B. 0.7 µA C. 700 µA D. 7 µA

1 answer 10 views

The following is correct : (A) P = V x I (B) P = I ² x R (C) P = V ² / R (D) All of the above

1 answer 19 views

A transmission line of 200 km has a certain A, B, C and D parameters. If the length is reduced to 60 km

1 answer 10 views

Which one is a vector quantity out of the followings?  A. Energy B. Volume C. Area D. Force

1 answer 233 views

Unit of frequency is ________________. A. Hz B. Horton C. dB D. Coulomb

0 answers 90 views

When The dc converter in figure shown has a resistance load of R = 10 Ω and the input voltage is Vs 220 V the converter switch remains on, its voltage drop is Vo -2 V. The chopping frequency is fI K sW Vs If the duty cycle is 50%, determine: (a) the average output voltage V (b) the RMS output voltage Vo (c) the converter efficiency (d) the effective input resistance of the converter

1 answer 27 views

In 8086 microprocessor , the address bus is ________ bit wide A. 12 bit B. 10 bit C. 16 bit D. 20 bit

1 answer 17 views

In computer system Scanner is _________device. A. Input B. Output C. Both D. None

0 answers 15 views

The sequence in which the speed is increasing in ascending order  a. RAM  b. Hard disk  c. Cache  d. Thumb Drive/Memory Stick  (1) dbac (2) bdac (3) badc (4) abdc

1 answer 7 views

Unit of Power is_____________. A. Watt B. Joule C. Ampere D. Coulomb

1 answer 8 views

3.2 x 10-5 A, equivalent to: A. 32 µA B. 3.3 µA C. 320 Ma D. 3,200 mA

1 answer 11 views

In air-core cable the surge voltage travels approximately at the speed of light and a cable of 100m length gives a delay of a. 0.666μsec b. 0.333μsec c. 1.555μsec d. 1μsec

1 answer 27 views

When the voltage across a battery is measured using a D.C potentiometer, the reading shows 1.08 V. But when the same voltage is measured using a Permanent Magnet Moving Coil (PMMC) voltmeter, the voltmeter reading shows 0.99 V. If the resistance of the voltmeter is 1100 Ohm , the internal resistance of the battery, in Ohm , is (A) 150 (B) 100 (C) 50 (D) 200

1 answer 37 views

The IF is called as _________ A. initial flag B. indicate flag C. interrupt flag D. inter flag

1 answer 20 views

The OF is called as _______ A. overflow flag B. overdue flag C. one flag D. over flag

1 answer 24 views

The SF is called as ________ A. service flag B. sign flag C. single flag D. condition flag

1 answer 18 views

The CF is known as ________ A. carry flag B. condition flag C. common flag D. single flag

1 answer 24 views

The work of EU is ________ A. encoding B. decoding C. processing D. calculations

1 answer 27 views

The intel 8086 microprocessor is a _______ processor A. 8 bit B. 16 bit C. 32 bit D. 4 bit

1 answer 8 views

Fuse wire protection system is usually not used beyond: a. 10A b. 25A c. 50A d. 100A

1 answer 6 views

If the no load voltage of a certain generator is 220V and the rated load voltage is 200V, then the voltage regulation is: a. 1% b. 10% c. 20V d. 9%

1 answer 15 views

Of the following, ____ is not a computer language. a) MS-Word b) C++ c) COBOL d) BASIC

1 answer 21 views

Of the following, ____ is different from the group.  a) Windows b) MS-Word c) MS-Excel d) MS-PowerPoint

1 answer 13 views

Which of the following is not computer hardware? A. Printer B. CPU C. Monitor D. Antivirus

1 answer 9 views

A medium line with parameters A, B, C, D is extended by connecting a short line of impedance Z in series The overall ABCD parameters of the series combination will be?

0 answers 17 views

Briefly define each of the following: (a) 1 coulomb (b) 1 volt (c) 1 ampere (d) 1 ohm.

1 answer 101 views

The microprocessor can read/write 16 bit data from or to ________ A. memory B. I /O device C. processor D. register

1 answer 6 views

Define the following terms as referred to battery. a) E.M.F b) Internal resistance c) Ah efficiency d) WAh efficiency

1 answer 12 views

The third generation relays - digital relays - are the basis of distribution system automation because of their: a. Self fault diagnostic capabilities b. Computing capabilities c. Easy interface for remote communication d. All of the above

1 answer 16 views

The degree of protection by ground wire depends upon the a. Arcing angle b. Shielding angle c. Power factor d. All of above

1 answer 22 views

Which of the following quantity maintains the same direction whether a D.C. machine runs as a generator or as a motor a. Induced e.m.f. b. Armature Current c. Field Current d. Supply Current

1 answer 10 views

Computer keyboard can be classified as ________device. A. Memory B. Input C. Output D. Storage

1 answer 12 views

RJ 45 UTP cable has _____cables. A. 2 Pairs B. 3 Pairs C. 4 Pairs D. 5 Pairs

1 answer 9 views

Find the odd one out A) MS -Excel B) Windows XP C) Linux D) DOS

0 answers 17 views

In a d.c. machine the force on a conductor placed on the periphery of the conductor is (a) directly proportional to parallel path (b) inversely proportional to the parallel path (c) inversely proportional to the length of the conductor (d) none of these

0 answers 27 views

A series R-L circuit is suddenly connected to d.c. voltage source of V volts. The current in this series circuit, just after the switch is closed, is equal to (1) Zero (2) V/L (3) V/C (4) V.L/C

1 answer 23 views

In a d.c. series motor, the torque developed is 20 Nm at 10A. If the load current is doubled, the new torque will be : -  a) 60 Nm b) 45 Nm c) 80 Nm d) 100 Nm

1 answer 15 views

The number of parallel paths in the armature winding of a 4 -pole, wave connected d.c. machine having 28 coilside is : -  a) 28 b) 14 c) 4 d) 2

1 answer 21 views

Which among these is a type of internal wiring? A. Cleat wiring B. Conduit wiring C. CTS wiring

1 answer 33 views

Which type of earthing is also called as 'fire earthing'? A. Plate earthing B. Rod earthing C. Strip earthing

1 answer 18 views

Consider the star network shown in figure. The resistance between terminals A and B with C open is 6 ohms, between terminals B and C withAopen is 11 ohms and between terminals C andAwith B open is 9 ohms. Then RA, RB, RC respectively is

0 answers 58 views

Two d.c. series motors connected in series are driving a mechanical load. If the motors are connected in parallel to drive the same load, the speed becomes  (a) slightly less than double (b) slightly less than half (c) slightly more than double (d) slightly more than half

1 answer 16 views
1 answer 19 views
1 answer 17 views
1 answer 38 views

For a two -port reciprocal network, the three transmission parameters are A = 4, B = 7 and C = 5. What is the value of D ?  (a) 9.5 (b) 9.0 (c) 8.5 (d) 8.0

0 answers 17 views

For a two port symmetric bilateral network, if A= 3Ω and B = 1Ω, the value of parameter C will be  (A) 4s (B) 6s (C) 8s (D) 16s